User manual CANDY CBG 51 X

[. . . ] - This device must be connected to the supply network through eiter a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnec t the elec trical plug prior to any maintenance. [. . . ] The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (fig. The air is released back into the room through air exhaust piping which passes through the cabinet and is connected to flange H (fig. The light on the cooker hood is designed for use during cooking and not for general room illumination. Replacing the acrylic or metal panels To replace the acrylic or metal panels, first remove grille D by pressing the two side buttons A, as shown in figure 3. To replace the halogen lamps B, from the inside of the cooker hood press downwards with two fingers as shown in Fig. If the cooker hood is at speed level 1 it will not be necessary to depress the push-button to switch the cooker hood off. Touching the key at 3rd speed, the intensive function runs for 10', then the appliance go back to work at the original speed. Key E = The Timer times the functions on activation for 15 minutes, after which they are switched off. When the Timer is activated the decimal point must flash on the display. The "clean air" function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of the peripheral segments must be visualised on the display. When this time has passed the motor switches off and the fixed letter "C" must be visualised on the display until the motor re-starts after 50 minutes for another 10 minutes and so on. Press any key apart from the light keys to return to normal functioning. Active carbon/grease filter saturation: - When display item C flashes, at a speed where it alternates with the letter F (e. - When display item C flashes, at a speed where it alternates with the letter A (e. [. . . ] By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. (*) The "automatic stop timer" delays stopping of the hood, which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. [. . . ]