User manual CANDY CBT63 X

[. . . ] Its use for any other purpose must be at your own responsability and may be dangerous. * You should contact the nearest Qualified Technical Assistance Service for any repairs always using original spare parts. Repairs and modifications carried out by others could damage the apparatus or cause it to malfunction, and risking your safety. The manufacturer cannot be held liable for inappropriate use of the apparatus. [. . . ] A cloth moistened in this water is used for cleaning the extractor, paying special attention to the grids. Note: * Never use metallic scouring pads or abrasive products that could damage the surface. * Do not use scrapers with metallic surfaces such as knives, scissors etc. * To install the charcoal filter, the motor anchorage is made to coincide with the anchor points of the activated charcoal filter and turn it clockwise. * The carbon filter lasts from three to six months depending on the particular conditions of use. * To replace exhausted filters with new ones, withdraw the old one in the reverse order to that of installation. Before carrying out any cleaning or maintenance activities, ensure that the extractor is disconnected from the mains. To carry out cleaning and maintenance, follow the Safety Instructions. To withdraw the filters from their locations release the anchoring points. Clean the filter, either by putting it in the dishwasher (see notes) or leaving it standing in hot water to simplify the removal of grease or, if wished, by means of special sprays (protecting the non metallic parts). Notes: cleaning in the dishwasher with aggressive detergents may blacken the surface of metallic parts, without this affecting its gas retaining properties. The filter must be cleaned at least once a month depending on how often the extractor is used. It must be remembered that grease is deposited in the extractor when cooking, whether it is switched on or not. * Take care to disconnect the mains beforehand and that the bulbs to be replaced are not hot. Although venting to the outside is recommended, activated carbon filters may be used, which allow the gas to be returned to the kitchen through the outlet pipe. IIf you wish to exchange the front for one matching the kitchen units, follow the following instructions (Fig. * Remove the screws (T) that support the front I* Install the new front fixing it with the same screws that held the old one. The lower part of the extractor must be located at a minimum height of 60 cm above the hob for electric cookers and 65 cm for gas cookers. if the instructions of a gas cooker indicate a greater distance these must be observed. When the extractor is working at the same time as other non-electrical cooking equipment, the outlet air pressure must not exceed 4 Pa (4 x 10-5 bar). [. . . ] This apparatus has the marked CEE in conformity with Standard 2002/92/EC of the European Parliament and the Council about remainers of electrical en electronic apparatuses. The correct elimination of this product avoids negative consequences for the market and the health. Symbol (in the product or in the documents that are included with it), indicates that it's not possible to be treated like domestic remainder. it's necessary to give it in a collection point to recycle electrical and electronic apparatuses. [. . . ]