User manual CANDY CDI32

[. . . ] It must be kept intact and within easy reach during the entire life of the cooktop. Please carefully read this manual and all the instructions contained herein before using the appliance. Installation and all gas/electric connections must be carried out by a qualified technician in accordance with the manufacturer's instructions and in full compliance with current laws and safety regulations. This appliance is intended solely for domestic use and is designed for the following functions: cooking and reheating food. [. . . ] 19) The glass-ceramic cooktop permits rapid vertical transmission of heat from the heating element below the cooktop to the pots or pans placed on top of it. Heat does not spread horizontally, thus at a distance of just a few centimeters from the cooking zone, the glass remains relatively cool" to the touch. This appliance is equipped with a "residual heat" indicator that lights up if the temperature of the hob is above 70°C, even when turned off. Residual heat persists for a relatively long time after the cooking zone has been switched off. Absolutely do not touch the cooking areas or leave flammable objects near it until the lamp is off. The indicator lamp turn off automatically once the temperature of the cooking zone falls below 70°C. To start the extensible zone turn the knob over position "10" until a release is felt, then turn the knob back and choose any position between 1-10 (energy regulation). - Never use pots or pans, these could scratch the glass and damage the working; - Aluminium film or papers are not suitable for this appliance; - Do not use acid, toxic or corrosive cleaners, for safety health. 18 To turn on the element, turn the knob clockwise; this sets the relative thermostat, with settings from "1" to "10". It is normal for some types of lamp to show a little light even when the plates are not working. Using the grid: Before using the grid, it is always advisable to check that it is firmly positioned and correctly placed on the hob. When the heating element comes on, two lights, one green and one red, light up. It is normal for some types of lamp to show a little light even when the plates are not working. Advice and warnings: Put the frying oil in the container provided before switching on the heating element. After cooking, wait for the oil to cool before emptying the container. If the regulator thermostat fails, a thermostat with manual reset will be activated; this must be reactivated by a skilled engineer. - The appliance must be installed correctly, in compliance with current laws. - Before carrying out any operation on the appliance, it must be disconnected from the electric supply. fitting the appliance in the worktop The cooktop may be fitted into any worktop, as long as it is heat resistant (minimum temperature of 90°C) The dimensions of the hole to be made in the worktop and the minimum distances between rear and side walls and those above the appliance are shown in figure 4. - If the cooktop is installed without an oven below it, a separator panel must be placed between The bottom of the cooktop and the housing below it, at a minimum distance of 10 mm. [. . . ] The burners, comprising two parts, can be removed and cleaned using suitable detergents. After cleaning, dry the burners thoroughly and reposition them carefully in their seats. In models with electric ignition, always check that the electrode "E" (fig. Upon completion of cleaning, replace the burners accurately in their seats. [. . . ]