User manual CANDY CIDT 61 X

[. . . ] A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. [. . . ] - Take the lower part of the telescopic structure C and insert it into the upper structure B (fig. Please note: To avoid scratching the upper duct, first adjust its height as desired, using the measurements given in (Fig. 6) as a reference, and then fix it in place using the 8 screws provided G (Fig. - Extractor hood: connect the flexible hose H (not supplied) to the air exhaust hole made previously and fix the hose to the connector flange F (Fig. - The active charcoal filters must be fitted to the extraction assembly located inside the cooker hood (Fig. Before proceeding with the installation process, open the panel by pressing on the point indicated in Fig. If the product is supplied with active charcoal filters, remove them by pulling the lever outwards as indicated in Fig. Remove the protective materials from the upper duct Y, as indicated in figure 10A. - Take the upper duct Y and fix it to the structure using the 2 screws X (Fig. Join the lower part of the cooker hood L to the upper duct Y until it clicks into place, then secure it in this position on the lower part of the cooker hood using the 4 screws A as indicated in figure 11. - Electrical connection Before performing this connection, loosen the 4 screws D on the two boxes and open the cover panels (Fig. - Perform the necessary electrical connections between the cooker hood body and the motor assembly (Fig. On constant maintenance; the anti-grease filter and the active carbon filter both require special attention. The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). [. . . ] As soon as this function is activated the motor star ts up at the first speed for ten minutes, During this time key F and key C must flash at the same time. After ten minutes the motor switches off and the LED of key F remains switched on with a fixed light until the motor starts up again at the first speed after fifty minutes and keys F and C start to flash again for ten minutes and so on. [. . . ]