User manual CANDY CIL170

[. . . ] in case of doubt , request an accurate control of the system by a qualified technician (Act 46/90). Some fundamental rules must be observed in the use of this appliance, as with any electrical equipment: · Do not touch the appliance with moist or wet hands or feet · Do not pull on the power supply cable to pull the plug from the socket Thank you for choosing this appliance. Please carefully read these short notes so that you can use all the available functions to a maximum. The quality of the refrigerator is guaranteed since our product is 100% tested at the end of production, with extensive trials and various types of TESTS. [. . . ] Position the handle in line with the holes and fasten in position using the screws provided. 5) The above, which is placed over the condenser, is assembled with three screws which are supplied in a packet inside the refrigerator During assembly ensure that the laminate sheet is wedged firmly into the appropriate slot on the ventilation grid. Remove the bush (B) and replace it with that supplied on the other side. After having fitted the door correctly in its housing, re-assemble pin (A). Remove the two screws which fasten the centre hinge (4) and remove the door (5). From both doors remove the bushings and relative caps and reinstall them on the opposite side (bushings to the left, caps to the right). Fasten the center hinge (4) together with the plastic shim underneath on the | opposite side to hold the freezer door in place. THE FOLLOWING CODE: GREEN AND YELLOW - EARTH BLUE - NEUTRAL BROWN - LIVE As the colours of the wires in the main lead of your appliance may not correspond with the coloured marking identifying the terminals in your plug, proceed as follows. CONNECT GREEN & YELLOW coloured wire to plug terminal marked letter "E" or earth symbol or coloured green or green & yellow. Always disconnect the appliance from the electricity before any type of repair or cleaning. The apparatus must equipped with an omnipolar switch, from the supply network with contact openings of at least 3 mm. Check that the main voltage corresponds to that indicated on the rating plate in the lower left side inside the freezer compartment. If the wall socket does not have an earth terminal, or if the plug does not fit into the socket, it is advisable to consult a qualified electrician. Do not use multiple plugs or adapters as they could cause heating and burning. WARNING: THIS APPLIANCE MUST BE EARTHED If this appliance is fitted with a non rewirable plug for which your socket is unsuitable, the plug should be cut off and an appropriate plug fitted. The removed plug must be disposed of Insertion of the plug into a 13 Amp socket is likely to cause an electrical hazard When a nonrewirable plug ora rewirable 13 Amp (BS1363) plug is used it must be fitted with a 13 Amp ASTA approved (BS1362) fuse. If any other type of plug is used it must be protected by a 15 Amp fuse either in the plug or at the distribution board IMPORTANT: THE WIRES IN THE MAIN LEADS ARE COLOURED IN ACCORDANCE WITH In this case the knob must be turned to a less cold position to allow automatic defrosting and, consequently, lower energy consumption. WARNING: Do not use mechanical devices or other artificial means to accelerate the defrosting process, other than those recommended by the manufacturer. [. . . ] When placing food inside the refrigerator compartment, take care that nothing touches the back panel. To prevent increase of humidity, with consequent increase of ice, liquids should not be stored inside the refrigerator in uncovered containers or uncapped bottles. The ice tends to concentrate on the coldest parts of the evaporator; thus, defrost operations will need to be done more often. It is necessary to clean the condenser once a year (black finned panel at the back) at least, with a dry brush or with a vacuum cleaner. [. . . ]