User manual CANDY CIVS 633

[. . . ] Do not place rough or uneven appliances, which may damage the ceramic surface. Clean the induction hob regularly to stop foreign objects from 2 getting into the fan and preventing the appliance from working properly. WARNING: The appliance and its accessible parts become hot during use. Children under 8 Year of age must be kept away from the appliance unless they are continuously supervised. [. . . ] Aluminium) has been left on the hob, a buzzer sounds for approximately one minute, after which the hob goes automatically on to standby. Residual heat warning When the hob has been operating for some time, there will be some residual heat. Auto shutdown Another safety feature of the induction hob is auto shutdown. The default shutdown times are shown in the table below: Power level 1~3 4~6 7~9 The heating zone shut down automatically after 8 hours 4 hours 2 hours Installation 1. Cut a hole in the worktop of the dimension shown in the diagram below. The worktop should be at least 30 mm thick and made of heat-resistant material. It is essential that the induction hob is well ventilated and that the air intake and exit are not blocked. Figure (2) Air exit mini 3 cm mini 5 mm mini 2 cm When the pan is removed from the cooking zone, it stops heating immediately and switches itself off after the buzzer has sounded for one minute. Warning: Anyone who has been fitted with a heart pacemaker should consult a doctor before using the induction hotplate. 6 Air intake Figure (2) NB: For safety, the gap between the hob and any cupboard above it should be at least 760 mm. Fix the hob to the worktop using the four brackets on the base of the hob. The position of the brackets can be adjusted according to the thickness of the top. warnings: (1) The induction hob must be installed by a properly qualified person. (2) The induction hob must not be installed above refrigerators, freezers, dishwashers or tumble dryers. (3) The induction hob should be installed so that optimum radiation of heat is possible. (4) The wall and the area above the hob should be able to withstand heat. (5) To avoid any damage, the sandwich layer and adhesive should be heat-resistant. Connection to power supply The socket should be connected in compliance with the relevant standard, to a single-pole circuit breaker. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to avoid any accidents. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3 mm between the contacts. The installer must ensure that the correct electrical connection has been made and that it complies with safety regulations. The cable must be checked regularly and only replaced by a properly qualified person. [. . . ] If the corresponding cooking zone displays a power level, then the vessel is suitable. If " " flashes, then the vessel is not suitable for use with the induction hob. If the magnet is attracted to the vessel, it is suitable for use with the induction hob. 6 Use pans whose diameter is as large as the graphic of the zone selected. [. . . ]