User manual CANDY CMD 97 X

[. . . ] 4): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Before fixing, the disposal duct for air evacuation to the outside must be installed. use an disposal duct with: ­ minimum indispensable length; ­ minimum possible bends (maximum angle of bend: 90°); ­ certified material (according to the State); ­ an as smooth as possible inside. [. . . ] Fixing to the wall: for fixing to the wall refer to the instructions for the ducting version (see point 2, 3), then continue with the instructions below. Fixing the telescopic flues: Using the supplied screws and screw anchors, fix the upper flue bearing bracket to the ceiling and/or wall, checking that it is aligned with the hood (Fig. Prepare the telescopic flues, remembering that their final position must be that illustrated in Fig. Take the air baffle and fit a flexible pipe to it (150 mm diameter) locking it with a metal hose clamp (pipe and clamps are not provided). Lift the lower flue upward and lock it temporarily with some adhesive tape: that way you can access the flexible pipe which must be connected to the flange on the air evacuation pipe (Fig. Remove the adhesive tape and bring down the lower flue gently and fix it by means of 4 screws working from the inside of the hood (Fig. Remember that charcoal filters must be used in the case of the filtering version; check to see whether such filters are already fitted; if necessary, proceed to fit as follows, depending on the model type purchased: - if the hood features a panel type charcoal filter (Fig. 15/16): Assemble the charcoal filter inserting the longer side of the filter into the groove that runs parallel with the grease filter seat. Holding the filter on its side, insert the lock supplied in its seat at the back (Fig. 15C) in order to avoid that it might be sucked onto the motor and bend it (Fig. 16A), putting them between the listel and the filter at the back of the seat of the filter. Keeping it blocked, make the lock rotate into the back part until it embeds, minding that the charcoal filter does not get into the inside of the hood. 17): Install the charcoal filter fitting the two filter clips in their housings and turning the filter upward. Installation is now complete and the grease filters can be reassembled. INSTALLATION IN VERSION WITH AN EXTERNAL MOTOR: Before fixing the hood the air evacuation pipe running from the hood to the intaking motor should be ready . use an air evacuation pipe with: ­ minimum indispensable length; ­ minimum possible bends (maximum angle of bend: 90°); ­ certified material (according to the State); ­ an as smooth as possible inside. [. . . ] Pay special attention to the grease filters: If the model purchased has the commands shown in Figure 19: the grease filter must be cleaned periodically: exactly how often depends on use (at least once every other month). To remove the filter: push inward on the clamp at the handle and pull the filter downward. If the model purchased has the commands shown in Figure 20: the grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. [. . . ]