User manual CANDY CTI 433

[. . . ] (In case of change of ownership, manual should be conveyed with the washing machine. ) IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electric shock, serious injury or death to persons when using your washing machine, follow basic precautions, including the following. CANDY washers are provided with a manual, including Operating Instructions, User Maintenance Instructions and Installation Instructions. Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry cleaning solvents, other flammable, or explosive substances as they give off vapors that could ignite or explode. Do not add gasoline, dry cleaning solvents, or other flammable, or explosive substances to the wash water. [. . . ] Maximum spin speed: 800 r. p. m. Soak Delicates Delicates settings are intended for use with delicate easy care items made from cotton, satin, synthetic or blended fabrics and curtains. We do not recommend washing these textiles with other rougher textiles. An intergrated soak cycle for pre treating of heavily stained items. Drain Water is drained after a program with the no final spin setting for gentle treatment of delicate laundry. 14 Spin speed selector Basic setting = Spin speed selector pointing upward at 1000 rpm. In the Regular/Cottons program the fabrics will be spun at the maximum possible spin speed. In the Permanent Press, Delicates and Hand Washables programs, a lower spin speed will automatically be used, regardless of the position of the spin speed selector - for the gentle washing of the laundry. Maximum spin speeds Revolutions per minute Type of laundry / Extra cycle Additional options buttons Power Wash Recommended for heavily soiled garments. The washing machine then heats the water to the selected wash temperature. By raising the temperature from cold through to the set temperature all components of the detergent are activated in stages for best stain removal and cleaning results. Rinse Plus When this button is depressed, an additional rinsing cycle will be added to the selected cycle. If both buttons for Power Wash and Quick Wash are pressed, only Quick Wash is running. 1000 800 600 800 800 Regular/Cottons Permanent Press Delicates Hand Washables Spin Additional function on spin speed selector no final spin For delicate laundry and net curtains. Use this setting to avoid wrinkles, when the clothing cannot be taken out of the washing machine immediatly upon completion of the cycle. 20 q Attach and tighten the pump cap. q Carefully remove the pump cap. q Attach and close the cover plate. To avoid unused detergent from flowing into the drain during the next wash cycle: q Pour 1 litre / 1 ¾ pt of water into chamber II. q Select the Drain program. q Remove any loose debris / lint from inside the pump and clean the pump. Clean any residual water or lint from the threads of the pump cap and pump housing. 21 Cleaning water inlet strainers This is necessary if very little or no water flows into the washing machine. First release the water pressure in the supply hoses: q Turn off the water taps. Cleaning the strainer(s) at the water tap On both the hot and cold water tap: Cleaning the strainers on the washing machine On both the hot and cold water tap: q Disconnect the hose from the back of the washing machine. q Disconnect the hose from the water tap. If water is still discharged, check that the strainer is attached properly. q Turn off the water tap. 22 Descaling the washing machine CAUTION Descaling agents contain acids which can attack parts of the washing machine and discolor the laundry. Provided that you use the correct amount of detergent, it is not necessary to descale the washing machine. If, however, descaling the appliance becomes necessary, please follow the instructions provided by the descaling agent manufacturer. Customer Service The washing machine requires no special care other than the care and cleaning noted above. If you are having a problem with your washing machine, before calling for service please refer to page 24. [. . . ] When washer is being installed in new construc tion, or a building that has had its plumbing sys tem recently installed or upgraded, the lines must be flushed prior to installing the washer. This must be done to clear the lines of any sand, dirt or residue that may still be in the lines. 31 Connection options A Cold water connection and B Hot water connection (max. 140 °F // 60 °C) Water drainage CAUTION Do not bend or pull the water drainage hose. Height difference between the placement area of washer and the drainage point: Maximum 110 cm // 43 inches. [. . . ]