User manual CARVIN 1588 V1

[. . . ] CARVIN ENGINEERING DATA 1588 SPEAKER SYSTEM INSTRUCTIONS REAR CONNECT PLATE Two standard 1/4" phone jacks and two SpeakonTM connectors are featured. See other side for hookup diagrams. SPEAKER CABLES Our standard cable for speaker hookups is the PH50. [. . . ] Like the smaller 1584, the 1588 gives you what other 3-way loudspeakers don't--studio quality sound in large sound reinforcement applications. The low frequency subsystem of the 1588 utilizes two heavy-duty 15" woofers, chosen for their extended bass response at high levels. The midrange employs two 8" direct radiating midrange drivers, for their exceptionally smooth and extended frequency response. The high frequency consists of one highly accurate titanium horn driver and lens assembly. All components are integrated with our 3-way C1588 crossover to deliver a system response that is smooth from 34 Hz to 19k Hz. Bi-amping can easily be done by selecting the bi-amp switch and input connectors. 1) DO NOT EXCEED THE POWER RATING marked on the rear connect plate. 2) DISTORTION from power amps will destroy drivers much faster than clean power. 3) WATER, MOISTURE, and DUST are harmful to drivers causing failure which is not covered under warranty. WARRANTY CARVIN loudspeakers are covered by a ONE year limited warranty unless otherwise stated. When returning defective driver(s), remove them from the enclosure to reduce shipping costs . Your driver(s) will be returned COD for the cost of shipping and reconditioning if not covered under warranty. 1588 FREQUENCY RESPONSE RECEIVING INSPECTION INSPECT YOUR SPEAKER FOR ANY DAMAGE which may have occurred during shipping. If any damage is found, please notify the shipping company & CARVIN. In the event you have to re-ship your unit, always use the original carton and packing material. [. . . ] INPUT 4 USA 1 588 SpeakonTM 1+SIGNAL 1­GROUND 2+ & 2­ NOT USED FULL RANGE ­PARALLEL BIAMP SW­LOW FREQ. INPUT 4 MADE IN THE USA IN (Set FREQ 600Hz) SUB LO HI ELECTRONIC CROSSOVER [. . . ]