User manual CATEYE OS 1.1
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CATEYE OS 1.1. We hope that this CATEYE OS 1.1 user guide will be useful to you.
Manual abstract: user guide CATEYE OS 1.1
Detailed instructions for use are in the User's Guide.
[. . . ] OS1. 1SE-011025 066600151 1
E
The position of the sensor and the magnet should be as shown:
Side view
Top view
Bracket Wire Speed sensor Bracket band Sensor spacer Magnet Nylon tie Bracket screw (long) Sensor screw (short) Lithium battery (CR2032) Bracket rubber pad
5 Main Unit
Fasten the screws securely
4 Bracket
Remove
Lever mark line less than 10 mm
Align the center of the magnet and the sensor's mark line while rotating the wheel or crank.
The clearance between the and the magnet sensor should be less than 10 mm.
3 Wire
To remove
2 Speed Sensor
Mounting View Front fork
Push
1 Magnet
Peel off Spoke
Pull
Caution!: Insure enough wire clearance in the area marked with to allow the handlebar to fully rotate without pulling the wire.
Rubber pad
C
Mount
· Names
Liquid crystal display START/STOP button [ENTER button] MODE button [SELECT button (FWD/REV)] MENU button RESTART button Contacts Battery cover
Setup
If "YES" is selected
· Custom Setup
Select your favorite functions and preferred font size. [. . . ] Maximum Speed (Mx) and Total Distance (Odo) continue to be measured regardless of start/stop.
2 Format operation
Format your unit before starting various setting. PRESS AND HOLD the two MODE/SELECT buttons, press and release RESTART button on the back of the OS. CONTINUE HOLDING DOWN the twoMODE/SELECT buttons for TWO MORE SECONDS and let go. Select YES and press ENTER/START/STOP button.
·Changing lower display
EASY -------- 14inch~27inch CUSTOM --- 100~3999mm (See "Tire Size Calibration Chart" page 16. )
How to Use
Countdown* Elapsed Time (Tm) Trip Distance (Dst) Counterclockwise Clockwise Clock Time
1 Installing battery
CLOSE
How buttons work in the SETUP process:
OPEN Battery (CR2032) START/STOP button (ENTER) PRESSING FWD BUTTON: Moves to the right or increases the figure PRESSING REV BUTTON: Moves to the left or decreases the figure PRESSING BOTH FWD/REV BUTTONS: Goes back to the previous screen PRESSING ENTER BUTTON: Enters the figure and executes the selection
· Icons on the screen
1 Screen 2 Battery life indicator 3 Selected tire icon 4 Auto mode icon 5 Speed scale icon 6 Pacer 7 Selected function icon
Average Speed (Av) Totall Distance (Odo) Maximum Speed (Mx) * appears when the countdown function is on. [. . . ] (See "Countdown setting" page 15. )
·Reset operation
Press START/STOP/ENTER button and either of MODE/ SELECT button simultaneously, and the data other than Press simultaneously Total distance (Odo) and Clock Time is reset.
REV FWD MODE button (SELECT) [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CATEYE OS 1.1
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CATEYE OS 1.1 will begin.