User manual CDA EVH9

[. . . ] In certain circumstances electrical appliances may be a danger hazard. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. G) This appliance is not intended for use by young children or infirm persons without supervision H) Young children should be supervised to ensure they do not play with the appliance I) There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels L) There is a risk of fire if cleaning is not carried out INSTALLATION INSTRUCTIONS Assembly and electrical connections must be carried out by specialised personnel. [. . . ] - When carrying out the fixing operations, use only screws and screw anchors suited to the type of wall (e. g. - If the screws and screw anchors are supplied with the appliance, make sure that they are suited to the type of wall to which the hood must be fixed. · INSTALLATION OF MODELS WITHOuT DECORATIVE DuCTS EXTRACTOR HOOD - Remove the 4 screws B as shown in (Fig. 9A). - Remove both grid E on the air outlet hole and lid M as shown in (Fig. 9B). - Connect the hood to the flexible hose (not supplied) and the hose to the air exhaust hole previously prepared (Fig. 9C). - Fix the lid once again by using the 4 screws previously removed in (Fig. 9A). · OPTIONAL ACCESSORIES This model may have decorative ducts as optional accessories - ask your retailer for information. Before fixing the decorative ducts, remove both the 4 screws B and lid M, as shown in (Fig. 10A-B). A sound-absorbing kit is also available (to be ordered as an OPTIONAL accessory) in order to increase the quietness level of the hood. The sound-absorbing layer must be applied to the back of the decorative panel. For fixing operations, refer to the instructions supplied with the kit. · INSTALLATION OF MODELS WITH DECORATIVE DuCTS Make sure the electrical power supply is within the measurements of the decorative connector. Adjust the width of the support bracket of the top connector (Fig. 11C). Then fix it to the ceiling so that it is on the same axis as the hood using screws A (Fig. 11C) adhering to the distance from the ceiling shown in (Fig. 11B). Connect flange C to the air exhaust hole using flexible hose L (Fig. 11D). Pull out the top duct as far as the bracket and fix it using screws F (Fig. 11C). · FILTER HOOD Please note: The filters should be ordered as accessories from your retailer. We offer 2 different types of kit which can be used to transform the EXTRACTOR hood into a FILTER hood, in accordance with the type of appliance model purchased. 14) included in the product packaging, this should be fixed to the hood using the 6 screws supplied. To replace the active carbon filters pull lever B outwards as shown in (Fig. 10). 2- If your product is not supplied with a bracket, this means that the active carbon filter is a circular version (fig. The filters should be fitted to the extraction assembly inside the hood, by centring them and rotating them 90 degrees, until they click into place (Fig. [. . . ] When the Timer is activated the decimal point must flash on the display. The "clean air" function is activated by pressing key E for 2 seconds when the appliance is switched off. This switches the motor on for 10 minutes every hour at the first speed. During functioning a rotary movement of the peripheral segments must be visualised on the display. [. . . ]