User manual CHAMBERLAIN 379E

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 379E. We hope that this CHAMBERLAIN 379E user guide will be useful to you.


CHAMBERLAIN 379E : Download the complete user guide (7087 Ko)

Manual abstract: user guide CHAMBERLAIN 379E

Detailed instructions for use are in the User's Guide.

[. . . ] NOTE: Do not attempt swiping your finger across sensor strip until you are ready to enroll as you may inadvertently begin the enroll process. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1. NEVER permit children to operate, or play with remote control transmitters. [. . . ] Swipe finger slowly and firmly down the sensor strip until three passed swipes are made. New user should swipe finger slowly and firmly down the sensor strip until three passed swipes are made. NOTE: If cover is already open, press either the Resend or the Enroll button to turn unit on. NOTE: If cover is already open, press either the Resend or the Enroll button to turn unit on. NOTE: The unit must have an enrolled user before it can be programmed to the opener. Due to the 30 second time interval, a second person may be needed to press the "learn" button. Press and release the "learn" button on the motor unit of the garage door opener. Within 30 seconds of pressing the 3 "learn" button, slowly and firmly swipe enrolled finger. NOTE: If cover is already open, press either the Resend or the Enroll button to turn unit on. During this time the only way to reverse or stop the door is to press the Resend button. After a passed swipe the Pass LED will light followed by a lit Send LED. If the opener lights don't flash, press and release the Resend button at 1 second intervals for up to 5 seconds until the opener lights flash or the door moves. NOTE: If unit will not program to opener repeat the steps above or refer to Troubleshooting. After 15 seconds the Enroll and Ready LEDs will light indicating fingerprints are erased. If finger is enrolled but unit will not program to opener: - Ensure that the opener has an orangee "learn" button. If opener does not have an orange "learn" button it is not compatible with the unit. [. . . ] If no known enrolled users are available: - The memory must be erased using the Factory Reset process. If the unit does not recognize a swiped fingerprint: - Ensure that the Ready LED is lit before you swipe. - Ensure that sufficient pressure is being applied to sensor strip (do not press too hard). [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 379E




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 379E will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.