User manual CHAMBERLAIN 50-1950 INSTALLATION
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 50-1950. We hope that this CHAMBERLAIN 50-1950 user guide will be useful to you.
Manual abstract: user guide CHAMBERLAIN 50-1950INSTALLATION
Detailed instructions for use are in the User's Guide.
[. . . ] Assemble post bracket assembly by placing push-to-open bracket between the two post brackets as shown. [. . . ] Mount gate bracket to actuator side of operator with pin and hairpin clips (Figure 3).
Figure 1
3/8" Hex Bolt
Post Bracket Push-to-Open Bracket
Post Bracket 3/8" Flat Washer 3/8" Lock Washer 3/8" Nut
Figure 2
Center of Gate Hinge
5/16" Hex Bolt
7-3/4"
90° 7-3/4" Special Post Pivot Bracket for Push-to-Open Installation Pin Hex Bolt Post Bracket
Figure 3
Push-to-Open Bracket Flat Washer Lock Washer Pin Nut Hairpin Clip Gate Bracket
Hairpin Clip
7. With gate open and operator in retracted position, clamp bracket to cross member, using C clamp. Once brackets are clamped in place, remove clevis pins and washers to detach operator. Be sure to mark holes in the vertical center of post bracket slots (Figure 5). Drill 13/32" holes in marked locations for gate post and 11/32" for gate bracket. Secure post bracket assembly to gate post with 3/8"-16 x 6" carriage bolts, flat washers, lock washers and nuts. [. . . ] Reconnect power to operator.
Batteries Control Board and Mounting Plate
01-32479B
© 2008, The Chamberlain Group, Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 50-1950
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 50-1950 will begin.