User manual CHAMBERLAIN 753 INSTALLATION
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 753. We hope that this CHAMBERLAIN 753 user guide will be useful to you.
Manual abstract: user guide CHAMBERLAIN 753INSTALLATION
Detailed instructions for use are in the User's Guide.
[. . . ] Single-Button Remote Control
Model 750
3-Button Remote Control
Model 753
Figure 1
750 Series 753 Series 756 Series Push Buttons
Mini 3-Button Remote Control
Model 756
() (+) (0) ()
(+) (0)
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: · ALWAYS keep remote controls out of reach of children. [. . . ] Place remote controls side by side as shown and set Match code switches (2-9) between old transmitter and switches in all remote new transmitter controls to matching positions (+, 0, -). NOTE: Code switch #1 on the Multi-function remote control is dormant when used with a single-function remote control. Set dip switch #1, in the single-function remote control, to match the push button selected on the Multi-function remote control (Figure 1).
0 + 0 + 1 2 3 4 5 6 7 8 9 1 2 3 4 5 6 7 8 9
AVERTISSEMENT ATTENTION
+ 0 1 2 3 4 5
Programming the opener
RED-1 WHT-2
H I G H N
0
+
0
+
Replacing the remote control battery
WARNING
To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. Locate the battery by either removing the case screw and the cover, or by sliding the battery compartment cover. Dispose of old batteries properly.
CAUTION
AVERTISSEMENT ATTENTION
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
1 2 3 4 5 6 7 8 9
6
7
8
9
ORM
OR
RED-1 WHT-2
H I G H N ORM
If your unit has a "Learn" button:
1. Press and release the "learn" button located on the back panel of the motor unit. Within the 30 second window, press and hold the button on the hand-held remote. [. . . ] Once the dip switches have been set push the remote control button to activate your unit.
+ 0 1 2 3
+ 0
H I G H N
4
5
6
7
8
9
OR
AVERTISSEMENT
1 2 3 4 5 6 7 8 9
AVERTISSEMENT
114A1316E
© 2006 The Chamberlain Group, Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 753
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 753 will begin.