User manual CHAMBERLAIN 771EML INSTALLATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 771EML. We hope that this CHAMBERLAIN 771EML user guide will be useful to you.


CHAMBERLAIN 771EML INSTALLATION: Download the complete user guide (1428 Ko)

Manual abstract: user guide CHAMBERLAIN 771EMLINSTALLATION

Detailed instructions for use are in the User's Guide.

[. . . ] Declare, that the following machinery complies with all the essential health and safety requirements of the Directive Description of machinery: Photocell Type of machinery: PEC-0001 EU Directives: EC Directive for low voltage 2006/95/EC EC Directive electromagnetic compatibility 2004/108/EC with amendments Applicable harmonized standards: EN 55011, EN 55014, EN 60555-2/-3 B. Non-compliance with the checking and adjustment requirements for the safety reverse system can result in a closing door causing serious, life-threatening injuries. An appropriate test should be carried out and repeated on a monthly basis. [. . . ] When the light beam is interrupted during the closing process, the door stops and re-opens completely. When the light beam is interrupted during the opening process, the door stops completely or stops until such time as the beam is no longer interrupted (depending on the given control unit and adjustment settings). The control units permit the connection of several pairs of light barriers. The sensors must be mounted securely to a solid surface and be located exactly opposite each other. Very important to note in this connection is that the slope or inclination of entrances be given due consideration. Light from a low sun or excessively thin cable can seriously restrict the range available. If two pairs of light barriers are mounted closely together (sliding door), the receiver/transmitter may not be located on the same side of the entrance as otherwise one transmitter lens would influence the two receiver lens. For the protection of infants and small children, the safety light barrier should not be installed higher than 200mm-250mm above the garage floor. ASSEMBLY/MOUNTING The power supply must be disconnected prior to assembling/mounting the safety light barrier. Align sensor such that the lens are located laterally to the door and point exactly at each other. Inside the garage, use insulated staples to fasten the cable to the wall and ceiling. Outdoors, only use cable approved for such applications and, if necessary, run it through an empty tube. High voltage and low voltage may not be run together through one cable as this may disrupt the sensors. Ensure that the sensors are sufficiently watertight and that the rubber gasket is used for cable connections. 5mm²) to the terminals as shown depending on the given control unit (figs a-h). Garage door openers: Select the model of your choice from the figs (a, b, c, d, e). [. . . ] Consult a specialist in cases where the opener closes the door despite its path being blocked by an obstacle. In cases where the transmitter or receiver indicator light does not light up after installation, please check the following: · In cases where both sensors are flashing: · You must ensure that the signal from the light barrier recognises the presence of persons or objects (vehicle). Without additional safety precautions, the sensors do not guarantee total safety. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 771EML




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 771EML will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.