User manual CHAMBERLAIN 835LM
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 835LM. We hope that this CHAMBERLAIN 835LM user guide will be useful to you.
Manual abstract: user guide CHAMBERLAIN 835LM
Detailed instructions for use are in the User's Guide.
[. . . ] Model 835LM
Perimeter Alert
Overview
The Perimeter Alert uses a Passive Infra-Red (PIR) Motion Sensor to detect movement of people and vehicles, while allowing small animals to pass through undetected. The Base Station is powered by the AC adapter and the 4 AA batteries supply power in case of a power outage. [. . . ] 1
Assembly & Programming
Step 1
Step 3
AC Adapter Input
OPTIONAL A
Attach PIR Motion Sensor box to mounting plate with large silver screw. Tighten screw until PIR Motion Sensor stays in place when repositioned.
Plug in the Base Station. 4 AA batteries are optional in case of a power failure.
Step 2
B
Install 4 AA Alkaline batteries. (Lithium batteries recommended for colder environments. ) Test light will flash.
Step 4
A Learn Button
Switch Settings
Antenna PIR Motion Sensor
Switch #1 Learn Button Switch #2
A Ensure Base Station and PIR Motion Sensor are in close proximity to each other. OFF 15 Feet Detection Range ON 30 Feet Detection Range (Default) Switch #2: OFF Low Sensitivity ON High Sensitivity (Default)
OFF 1 2 ON
B
Learn Button
B Within 60 seconds, press the Learn Button on the inside of the PIR Motion Sensor. Test light will illuminate and Base Station will buzz.
NOTE: To avoid unwanted detection of small animals move Switch #2 to OFF.
2
PIR Motion Sensor Installation
Step 5 Step 7
Insert battery pack facing away from circuit board and fasten cover with the smallest screws (provided). NOTE: Ensure the batteries do not touch the circuit board and the antenna and battery wires are not pinched.
Mount PIR Motion Sensor horizontally on solid surface a few feet off the ground and within 1/2 mile of Base Station (rotate sensor to access screw holes). Do not mount PIR Motion Sensor in direct sunlight, near moving tree branches, or in the path of a sprinkler system. Vehicle Alert Installation: For cars, the best mounting position is about 4 feet high, between 10-20 feet back, and angled to see the back of car after passing the sensor.
Step 6
10' - 20'
3' - 5'
Test PIR Motion Sensor by waving hand in front of sensor. Test light should flash and the Base Station will buzz.
3
Troubleshooting
The PIR Motion Sensor lights up, but the Base Station does not respond. The PIR Motion Sensor must be programmed to Base Station (See Step 4). Keep both antennas vertical and keep PIR Motion Sensor antenna away from trees and metal objects. [. . . ] Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.
FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www. liftmaster. com
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
114A4079
© 2009, The Chamberlain Group Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 835LM
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 835LM will begin.