User manual CHAMBERLAIN 945CB
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN 945CB. We hope that this CHAMBERLAIN 945CB user guide will be useful to you.
You may also download the following manuals related to this product:
CHAMBERLAIN 945CB INSTALLATION (18 ko)
Manual abstract: user guide CHAMBERLAIN 945CB
Detailed instructions for use are in the User's Guide.
[. . . ] ®
WARNING
FOR USE WITH GARAGE DOOR OPENERS MANUFACTURED AFTER JANUARY 1, 1995. To ensure proper functioning of your opener, remove all old or previous push buttons/wall control panels. [. . . ] Fasten with 6ABx1-1/4" self-tapping screws (standard installation) or 6-32x1" machine screws (pre-wired installation) as follows: · (Standard Installation ONLY) Drill pilot holes and install bottom screw, allowing 1/8" (3 mm) to protrude above the wall surface. · Position bottom of door control on screw head and slide down to secure. (Standard Installations ONLY) Run bell wire up wall and across ceiling to motor unit. Use insulated staples to secure wire to wall and ceiling in several places. Do NOT pierce wire with a staple, this will create a short or open circuit. Connect bell wire to terminals as follows: · Quick Connect Terminals: Red/white wire to red terminal and white wire to white (Figure 1). Replace the cover by inserting the bottom tabs and snapping it into place. Press again to reverse the door during the closing cycle, or to stop the door while it is opening. Light Feature: Press the Light button to switch the opener light on or off. When the door is opened or closed, the light will remain on for 4-1/2 minutes. The Light button will not control the opener light when the door is in motion. Lock Feature: Designed to prevent operation of the door from portable remote controls. [. . . ] · Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. NEVER permit anyone to cross path of closing garage door.
Figure 1
Push Button Terminal Screws
RED WHT
Quick-Connect Terminals
Bell Wire
LOCK
LIGHT
Light Button
Lock Button Door Control Connections Strip wire 7/16" (11 mm)
7/16" (11 mm)
To release wire, push in tab with screwdriver tip
Antenna Red White Grey
OR Figure 2
Opener Terminal Screws
Push Button Terminal Screws
RED WHT
Bell Wire
LOCK
LIGHT
Lock Button
Light Button Opener Panel
Antenna
114A2381D
© 2006, The Chamberlain Group, Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN 945CB
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN 945CB will begin.