User manual CHAMBERLAIN ECO300K
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN ECO300K. We hope that this CHAMBERLAIN ECO300K user guide will be useful to you.
Manual abstract: user guide CHAMBERLAIN ECO300K
Detailed instructions for use are in the User's Guide.
[. . . ] This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal injury or damage to property. This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and operated in strict accordance with the following safety rules. Incorrect installation and/or failure to comply with the following instructions may result in serious personal injury or property damage. When using tools and small parts to install or carry out repair work on a gate exercise caution and do not wear rings, watches or loose clothing. [. . . ] Always make sure that water, humidity and condensation cannot enter the control box. It is vitally important that all openings and cable glands are sealed so that they are watertight. Wall plugs ELECTRICAL INSTALLATION Installing the electronic control board: the motor control board is a microprocessor-controlled electronic appliance featuring state-of-the-art technology. It is equipped with all the connecting options and functions needed to guarantee safe operation. The control box incorporating the motor control board should be installed with the cable intakes pointing downwards fig. The electronic equipment enables the pull and push forces to be set with great accuracy. If installed and set correctly, the gate/door can be stopped manually. When in motion, the gate/door can be stopped at any time by operating the remote control, the push-button or the keyoperated switch. The gate/door wing must be fitted with a robust end stop for the 'OPEN' and 'CLOSED' positions as the gate/door drive has no limit switches. Current distribution: the cable leading from the drive arm must be laid in a standard watertight distribution box. A permanently installed cable can be laid from the distribution box to the control unit. It is often possible to wire the drive, which is fixed beside the control unit directly to the box. Generally speaking, the following minimum cable crosssectional areas must be adhered to: 100-230Volt 1. 5mm2 or more Tips: Bell wire is often problematic in practical use because it loses too much voltage if long lengths of wire are used. Motor cable and light barrier cable, especially in the case of key-operated switches and ON switches (from the house wiring system) to prevent interference where long lengths of cable are used. OVERVIEW OF CONNECTIONS Motors: connect the control unit exactly in accordance with the overview of connections. The gate/door wing, which opens first, must be motor 1 (M1) and when it first moves it must OPEN the gate/door. If it closes the gate/door, swap terminal 6 with terminal 8 or, in the case of motor 2 (M2), swap terminal 9 with terminal 11. The capacitor supplied as standard must be installed between cables 6 and 8 and 9 and 11 (for space reasons, the capacitor can also be installed in a distribution box). Make sure that its terminals are properly connected and that there is a good electrical connection. INFRARED SENSOR The IR Sensor provides additional safety to the gate/door and must be used. Its point of installation depends on the design of the given gate/door. [. . . ] Then repeat the entire process until both wings open when they first move. If both wings open when they first move once the control unit has been connected, proceed as follows. Interrupt the power supply to the control unit and reconnect it after a few seconds. Then use the test button to switch on the control unit and observe what happens. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN ECO300K
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN ECO300K will begin.