User manual CHAMBERLAIN HC600 INSTALLATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN HC600. We hope that this CHAMBERLAIN HC600 user guide will be useful to you.


CHAMBERLAIN HC600 INSTALLATION: Download the complete user guide (4167 Ko)

Manual abstract: user guide CHAMBERLAIN HC600INSTALLATION

Detailed instructions for use are in the User's Guide.

[. . . ] Employ a qualified technician to repair the gate, never attempt to repair it yourself. Disconnect electric power to the system before making repairs or removing covers. install an all pole disconnect switch in the permanent wiring if one is not present. Make sure that people who install, maintain or operate the gate drive follow these instructions. [. . . ] The gate must be stable and as free of backlash as possible in order to prevent any unwanted to and fro movement. The more smoothly the gate leaf runs, the more sensitive the force adjustment must be. Note down any materials you still need and obtain them before starting to install. Now the drive can be unscrewed from the base plate (4x lock screws) (figure 6-8). The door leaf can move in an uncontrolled way, especially if it is defective and not properly balanced. The gate type (figure 2) determines the location where the drive mechanism is installed. If the gate stop is on the ground, the drive mechanism must also be installed at a height that is as low as possible so that it cannot twist the gate. If you are uncertain whether the available support is sufficiently stable, reinforce it. It is advisable to fit a plate from the outside so that the fixing brackets cannot become loose over time. Thin wooden gates must also be reinforced in order to withstand the stresses encountered. The release key should be inserted into the side openings and turned approx. To re-engage it, the key should be turned back to its original position (figure 11). The gate drive mechanism is suitable for use in conjunction with pillars with a max. The amount of room around the pier affects the opening angle and the position of the arms (figure 4). A different opening angle can be set for the left-hand wing as compared with the right-hand one (figure 3). Switch to manual operation by inserting and turning the hexagonal key provided (Fig. Make sure that the screws used are long enough to ensure stable mounting. In the case of thick brick or concrete pillars, the hinge plate should be welded onto a support plate, that is mounted in such a way that the plugs cannot work loose. Adhesive shear connectors are better than steel or plastic wedge anchors for this purpose. A threaded rod is then mounted into the masonry with a stress free adhesive seal. A watertight distribution unit should be mounted on the pier next to the hinge plate. The feed cable for the wing gate opener is led into this unit from underneath. [. . . ] Arrange the handover of the wing gate opener with your customer Make sure that persons will operate the gate are familiar with its functions and can operate them without problems. Have your customer practice operating the gate until he is fully acquainted with all the following: · Do not drive through while the gate is still opening). ⷠAdditional safety features (photoelectric barrier, flashing lights, etc. ⷠReference a checklist, so that you have a record of which functions have been explained and of any points not dealt with. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN HC600




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN HC600 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.