User manual CHAMBERLAIN RA4336

[. . . ] The remote controls in this product are only suitable for use in conjunction with shutter drives made by Chamberlain (F-Series). Disconnect the power supply to the drive (at least 10 seconds) · press and hold the STOP button on the "master" remote control · Re-connect the power supply now, wait and keep pressing and holding the button. 15 seconds the drive should turn briefly as a signal that it has understood the command. The drive should turn 2x briefly and then run to one of the limit switches as a signal that the command has been understood. [. . . ] If other signals are transmitted on this frequency, the range may be reduced significantly as the mixture of the signals causes the receiver in the motor to block release for safety reasons. ⷠWeather stations or radio-controlled temperature measuring devices transmit signals in cycles of 30-90 seconds for approx. Hand-held remote controls for garage doors transmit signals briefly when the door is opened. Headphones or other systems in households can also transmit signals via radio. ⷠAs a test, you can deactivate the various systems and see what happens. Can I operate several shutters simultaneously via a 1-channel remote control? ⷠThis is possible in the same room, but not advisable as both or all shutters are always operated at the same time. This is equipped with a mechanism whereby all the shutters can be automatically controlled either together or individually, as required. The middle button stops the shutter in any position as required (stop). If, during an upward or downward movement, the button for the reverse direction is pressed, the motor automatically changes the direction of travel. Make sure no electric cables are damaged when fitting the bracket, particularly when installation is to occur near light switches or power sockets. pROGRAMMING RADIO REMOTE CONTROLS (HAND-HELD TRANSMITTERS) Up to 40x remote controls can be memorised. The first remote control programmed is also called the "master" remote control. PLEASE NOTE: With regard to the 6-channel remote control, first adjust the remote control to the new channel (1-6). To this end, the remote control must be set to the "Individual Control" mode. PROGRAMMING A NEW, ADDITIONAL REMOTE CONTROL (not the first one or so-called master) PLEASE NOTE: The following steps must be executed quickly. The easiest way is for a second person to help by reading out the text while the other person presses the buttons. via the master remote control: Step 2: Press and hold the STOP button. [. . . ] Press and hold UP button or DOWN button (direction of movement) on the new "master" remote control (stay within radio range of drive) · Re-connect power supply and wait · If it has worked, the drive turns 2x briefly as a signal that the command has been understood. If the process doesn't work, it could perhaps be that a "master" remote control has already been programmed. Should this not be identifiable however, everything will first have to be deleted via "Deletion without remote control". Was the period between the connection of the power supply and pressing the button on the remote control longer than 20 seconds? [. . . ]