User manual CHAMBERLAIN SLY1000
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CHAMBERLAIN SLY1000. We hope that this CHAMBERLAIN SLY1000 user guide will be useful to you.
Manual abstract: user guide CHAMBERLAIN SLY1000
Detailed instructions for use are in the User's Guide.
[. . . ] Disconnect electric power to the system before making repairs or removing covers. A disconnecting device must be provided in the permanently-wired installation to guarantee all-pole disconnection by means of a switch (at least 3mm contact gap) or by a separate fuse. Make sure that people who install, maintain or operate the gate drive follow these instructions. Keep these instructions in a safe place so that you can refer to them quickly when you need to. [. . . ] If the drive gets too hot, it switches itself off until it has cooled down to activation temperature. The outdoor temperature and the gate itself are key factors determining the drive's actual duty cycle · Safety: A sliding gate drive has to be fitted with a flashing lamp, contact strips and, if necessary, with additional light barriers as safety features. Please ensure that you comply with the standards and regulations relevant to your particular case. Control unit: The control unit was developed specifically with safety aspects in mind. it is already located under the drive hood and wired up for right-hand installation as standard (motor to the right of the gate). CHECK LIST - PRE-INSTALLATION WORK 1 - 4 Prior to actual installation, please check that you have been provided with all the parts indicated within the scope of supply. The gate must run smoothly, not jerkily and not make contact with the ground at any point. Bear in mind that the ground can be several centimetres higher in winter. The gate needs to be stable with as little play as possible to prevent any lateral movement from occurring. The easier the gate moves, the more sensitive the force setting needs to be. Make a note of the materials you still need and make sure you obtain them prior to installation - adhesive anchors (strong plugs), screws, stops, cable, distributor boxes, tools, etc. The base plate for the drive can either be concreted in or, if appropriate, welded into position. The place where the base plate is usually located is shown on the installation overview. Please note: If it is impossible to precisely determine the height of the plinth and the distance from the gate prior to installation, it is advisable to mount the rack bars first and then concrete in the base plate. The distance from the bottom edge of the rack bar to the base plate is approx. The base plate permits final height and depth adjustments of several centimetres to be made, but you are advised to work as precisely as possible from the outset. Position the drive via the adjustment holes such that its location vis-à-vis the rack bar complies with the installation dimensions. MOUNTING RACK BAR 7 The easiest way to fit the rack bar is to first place it on the motor's drive cog, disengage the motor and, by pushing the gate further with the rack bar, screwing the bar bit by bit firmly in position. [. . . ] Electrical operation is only possible with the control unit that is supplied as standard. Always ensure that the mechanical and electrical safety requirements relevant to the given system are complied with. Check at regular intervals (monthly) that the gate hardware and the drive are all firmly in place. A sliding gate can also be secured by implementing on-site measures (fence, wall, etc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CHAMBERLAIN SLY1000
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CHAMBERLAIN SLY1000 will begin.