User manual CHAMBERLAIN TCTTX2E

[. . . ] You can also arrange for the roller shutters to open automatically in the mornings and close them manually in the evenings as well as vice versa. With the built-in radio transmitter you can also easily open and close other roller shutters without wires by means of a radio signal. The prerequisite for this is that these roller shutters are also equipped with transmitting and receiving units from the product series made by Chamberlain. In this way there is no time-consuming and expensive opening up of the walls. [. . . ] In program mode "A1" the roller shutters open and close each day automatically at the programmed times. In program mode "A7" the roller shutters open and close automatically each week day at individually programmed times. Automatic opening and closing the roller shutters at different times (according to the day of the week) 8. For each weekday you can also enter a different opening and closing time. Enter an opening time then confirm the hours and minutes with the UP key. Then enter a closing time and again confirm the hours and minutes with the UP key. Now select all the other weekdays and program the opening and closing times. The roller shutters will now open and close on each day individually according to the programmed times. If instead of entering a time you enter a double hyphen (--) this will deactivate the opening or closing time. You can use this function to automatically close the roller shutters in the evenings so that you can then open them manually in the morning or vice versa. Under the menu option Events you can easily switch between the two automatic programs. Under the menu option Autom you can switch off the automatic functions completely. Remote control of roller shutters which are equipped with the radio wall switch TCTX2E and the receiving module TCRX3E. The TCTTX2E can remotely control other roller shutters if they are fitted with a TCRX3E and a TCTX2E unit. The data from the automatically time-controlled opening and closing process can be transmitted as well as the manual control commands. With a special pointed implement press the learning key on the back panel of the TCTX2E. (If these roller shutters are controlled by several TCTX2Es, press the learning key on the TCTX2E master transmitter). Select On, in order to send all control signals and select Timer, just to send the programmed opening and closing times only. Remote-controlled switching of roller shutters, which are equipped with the TCRX2E receiver. The TCTTX2E can remotely control other roller shutters if they are fitted with the TCRX2E, TCTRX2E or TCRX3E unit. [. . . ] This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or replacement batteries. A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced (at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. Defective parts will be repaired or replaced with new or factory rebuilt parts at Chamberlain's option. If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase. [. . . ]