User manual CHANEY INSTRUMENT MODEL 0073400683W00683A2 WIRELESS THERMOMETER AND REMOTE SENSOR

[. . . ] Both the main unit and the sensor unit can be displayed on a desktop or hung on a wall. For desktop display pull out the foldable stand located on the back of the unit. To hang on a wall, slide the hanging slot located at the top center of the unit over a nail or screw (not provided) in the wall . [. . . ] To activate auto scroll, press the - button until the icon appears on the LCD display. MIN/MAX/MEMORY: The main unit automatically stores the high and low temperature. ß Pressing the max/min button will display the maximum temperature for 5 seconds. Press the button again to display the minimum temperature for 5 seconds. To clear the stored max/min temperatures, press the clear button while the value you wish to clear (max or min) is displayed. ß TEMPERATURE ALERT: Minimum and maximum temperature alerts can be programmed. To turn the feature on or off, press the alert button located at the back of the unit. Setting Cycle: ß To set the temperature at which the alert will sound, press the alert button for 3 seconds until the outdoor temperature and the upper/lower icon flash. Press the + or - button to select the desired channel; press the alert button to confirm the channel selection. Enter the desired upper limit temperature by pressing the +/- buttons; press alert to confirm. Enter the desired lower limit temperature with the +/- buttons; press alert to confirm and exit the temperature alert mode. When the temperature reaches either the upper or lower limit, the pointers and the temperature begin to flash and an alarm will sound. The temperature will continue to flash until the temperature changes from the upper or lower limit temperature. At times, the main unit may display ì---ì in the remote temperature screen if outside interference is occurring. However, if this should continue to occur, the following may also be the reason: A. The sensor has been placed outside of the effective transmission range (more than 100 feet). [. . . ] The main unit automatically searches for an open channel to register the signal for the new sensor. ß 2. TROUBLESHOOTING: ß 3. 4. C. Low Battery Indicator: The low battery indicator will appear on the LCD displays of both the main and sensor units. To replace the batteries, follow the setup procedure above. LIMITED WARRANTY: Should this product from the Chaney Instrument Co. [. . . ]