User manual CHANEY INSTRUMENT MODEL 00736 WIRELESS WEATHER FORECASTING STATION AND REMOTE SENSOR

[. . . ] Both the main unit and the sensor unit can be displayed on a desktop or hung on a wall. For desktop display pull out the foldable stand located on the back of the unit. To hang on a wall, slide the hanging slot located at the top center of the unit over a nail or screw (not provided) in the wall. Main unit: The main unit and sensor "communicate" using a built-in random security code. [. . . ] Select the existing weather condition by pressing the - button on the back of the unit. Press the + button to confirm the setting. Sunny Partly Sunny Cloudy Rainy Stormy THERMOMETER SET-UP: 1. Place batteries in the main unit by removing the battery cover panel on the back of the unit and inserting 2 AA alkaline batteries. Note: The battery panel is located behind the foldable stand/ mounting plate, which can be gently pried from the back of the unit. Before replacing the battery cover press the reset or the Tx button to send a signal to the main unit. On the main unit, select between Celsius and Fahrenheit temperature readings by pressing the + C/F button. To add an additional sensor make sure batteries are in the main unit first, then place batteries in the additional sensor and press the reset or Tx button. The main unit automatically searches for an open channel to register the signal for the new sensor. The weather forecaster will automatically read the atmospheric pressure and predict the weather conditions for the next 12 hours; this is based on calculations only and may not be representative of conditions. After initial set-up, the unit may need 12-24 hours to read atmospheric pressure. Pressure Trend Indicator: Pressure trend icons indicate steady, falling, or rising pressure. 4. Storm Alert: The cloud and rain icon will flash when the sensor unit detects stormy conditions. Day/Night Icon: The sun (indicating daytime) will change to the moon and stars (indicating nighttime) after 9:10 pm (21:10). The nighttime indicator will remain until 5:10 am (05:10), at which time the daytime indicator returns. MIN/MAX/MEMORY: The main unit automatically stores the high and low temperature. Pressing the max/min button will display the maximum temperature for 5 seconds. Press the button again to display the minimum temperature for 5 seconds. To clear the stored temperature, press the clear button while the value you wish to clear (max or min) is displayed. TROUBLESHOOTING: At times, the main unit may display "---" in the remote temperature if outside interference is occurring. However, if this should continue to occur, the following may also be the reason: A. The sensor has been placed outside of the effective transmission range (more than 100 feet). Sensor units may have outside interference that is preventing proper transmission. Sources of interference include but are not limited to metal surfaces, electrical devices, etc. [. . . ] A bell icon will appear in the time panel to show that the alarm is set. The alarm time will display for 5 seconds and then switch back to normal clock mode. Each time you press the snooze button the alarm will "snooze" for ten minutes, and then sound again. LAKE GENEVA, WISCONSIN 53147 www. chaneyinstrument. com LIMITED WARRANTY: Should this product from the Chaney Instrument Co. [. . . ]