User manual CISSELL 28ES30

[. . . ] The warranty period on each new replacement part furnished by Cissell in fulfillment of the warranty on new equipment or parts shall be for the unexpired portion of the original warranty period on the part replaced. With respect to electric motors, coin meters and other accessories furnished with the new equipment, but not manufactured by Cissell, the warranty is limited to that provided by the respective manufacturer. Cissell's total liability arising out of the manufacture and sale of new equipment and parts, whether under the warranty or caused by Cissell's negligence or otherwise, shall be limited to Cissell repairing or replacing, at its option, any defective equipment or part returned f. o. b. Cissell's factory, transportation prepaid, within the applicable warranty period and found by Cissell to have been defective, and in no event shall Cissell be liable for damages of any kind, whether for any injury to persons or property or for any special or consequential damages. [. . . ] 280 lb (127 kg) Export Shipping Weight (1 Box) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 435 lb (197 kg) Export Shipping Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47" (1194 mm) H, x 53" 1346 mm) L, x 20" (508 mm) W Export Crate Volume . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (0. 821 m3) Floor Space . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20" (508 mm) x 48" (1219 mm) Table Height (Adjustable) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37" (940 mm) to 44" (1118 mm) Length of Working Surface. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38" (965 mm) Width at Front End of Large Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 1/2" (165 mm) Width at Rear End of Large Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 1/2" (318 mm) Width at Front End of Swinging Sleeve Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1/2" (64 mm) Width at Rear End of Swinging Sleeve Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4" (102 mm) Boiler Horsepower (approximate) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . It is important that these drain holes are open in order that the vacuum can extract any liquids that form in the pan. CLEANING SWINGING ARM ASSEMBLY Lift out small green vitrelite glass by finger hole at back of pan. VACUUM SEAL The rubber air-foam gasket around pipe of top assembly at top of column is a seal to help create a stronger vacuum. CHECK VALVE Inspect and clean check valve located above drain receptacle. Liquids separated from the vacuum exhaust within the column are automatically drained from board by check valve. UPPER AND LOWER SLIDE A few drops of oil on the upper and lower slides of the swinging arm assembly will permit easier operation. Page7 SPOTTING BOARD OPERATING INSTRUCTIONS FOR REMOVING SPOTS Place garment in position over screened area of board so that spot is directly over the vacuum ring area. when it is impossible to use the large board, use the swinging sleeve board by swinging it forward and use it as you would the larger board. With garment in position, using one foot, press both the vacuum (left) and steam (center) foot pedals all the way down. CAUTION: Be sure to have the spotting gun pointed away from your face or body as live steam is very hot and may cause burns. Now, with gun in rotary motion (heavy arrows), spray wet steam downward straight through spotted area. Ample wet steam under pressure dissolves watersoluable spots instantly. [. . . ] Pedal Rod 31" Pedal Rod 26" Pedal Rod 21" Strap (3 reqd. ) Strap (1 reqd. ) Pedal (3 reqd. ) 1/4 - 20 x 3/4" Sq. Set Screw 3/8 - 24 Hex Nut 3/8 Cut Washer 3/8 Lock Washer 3/8 - 24 x 2 1/2" Hex. Bolt Page18 13 CENTRAL AIR VACUUM PARTS - VSB114 (VSB114 - Assembly does not include nos. FB32 V15 FB16 VA4 FB229 SF15 OP547 V345 V12 V2 Description Gasket Small Lock Nut Disc Valve Stem Air Vacuum Body Fork Large Lock Nut Spring (45 Lb. ) Gland Cottor Pin Ref. [. . . ]