User manual CISSELL KMAN589A

[. . . ] Charges for unauthorized repairs will not be accepted or paid by Cissell. CISSELL MAKES NO OTHER EXPRESSED OR IMPLIED WARRANTY, STATUTORY OR OTHERWISE, CONCERNING THE EQUIPMENT OR PARTS INCLUDING, WITHOUT LIMITATION, A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, OR A WARRANTY OF MERCHANTABILITY. [. . . ] The head is closed by hand and by foot operation of the central pedal. The head is opened by pressing down on the lever on the right of the head steam valve. The head steam is hand lever operated while the buck steam and vacuum are foot pedal operated. The improved leverage system and roller bearing pivot assures smoother, faster head operation and a quality finish. Page 5 INSTALLING THE PRESS 1. The Lowboy bracket (PR356) has been installed on the table at the factory. Then assemble the iron rest assembly (PR365, PR398 & PR401) to the shaft of PR356. (See Figure 1) FIGURE 1 (IRON REST) Page 6 INSTALLING THE PRESS (Continued) Steam and Vacuum Connections (See Figure 2) 5. Connect a 3/8 inch steam supply line to the press at a recommended pressure of 88 psi (6 bars). Install a 1/2 inch steam trap suitable for 88 psi (6 bars) in the line. 7. FIGURE 2 STEAM & VACUUM CONNECTIONS Page 7 Page 8 Description of the Manual Press The buck of the press is the bottom part of the press upon which the garment is to be placed and pressed. Three foot pedals are located near the floor at the front of the press. The right pedal activates the buck valve which ports upsteam to the buck. Operation of the Manual Press (Allow the press to warm up for 20 min. ) Lay the garment to be pressed on the buck. Apply pressure and lock the head by stepping on the middle foot pedal and applying toe pressure. [. . . ] Rear springs has gotten out of adjustment Re-adjust spring support plate. 3. No Vacuum_________________________________________________________________________ Cause Remedy A. The set collar on the vacuum valve connecting rod not adjusted properly. [. . . ]