User manual CYBEX ATON

[. . . ] ⷠIn order to adjust the handle press buttons b on left and right side on the handle a. Only if the shoulder belts c are adjusted correctly optimum security can be provided. ⷠWhen the baby is approximately 3 months the seat insert can be removed to provide enough space for the child (see page 29). ⷠThe height of the shoulder belts c must be adjusted in such a way that they run through the belt slots s directly above the baby`s shoulders. [. . . ] ⷠPull the diagonal belt l in driving direction to tighten the lap belt k. ⷠPull the diagonal belt l behind the top end of the baby seat. In some cases the buckle q of the car safety belt may be too long and reach into the belt slots of the CYBEX ATON, making it difficult to install the ATON securely. rEMOVING THE CAR SEAT · Take the seat belt out of the blue belt slot n in the back. ⷠOpen the car buckle q and take the lap belt k out of the blue belt slots m. SECURING YOUR CHILD CORRECTLY For the safety of your child please check . ⷠIf the shoulder belts c fit well to the body without restricting the baby · If the buckle tongues t are fastened in the buckle e INSTALLING THE BABY SEAT CORRECTLY For the safety of your child please make sure . ⷠThat the ATON is positioned against driving direction (the feet of the baby point in the direction of the backrest of the car seat) · If the car seat is installed in front, that the frontairbag is deactivated · that ATON is secured with a 3-point belt · That the lap belt k is running through the belt slots m on each side of the baby seat · That the diagonal belt l is running through the blue belt hook n on the back of the baby seat That the car buckle q is not reaching all the way to the blue belt slot m · That the car belt is tight and not twisted · that the ATON is vertically installed on the car seat (see marking) Note!The CYBEX ATON is exclusively made for forward facing car seats, which are equipped with a 3-point belt system according to ECE R16. REMOVING THE INSERT The insert, which is preinstalled when purchased, helps to support lying comfort and fit for the smallest babies. In order to remove the insert please loosen the cover in the baby seat, lift the insert a little bit and take it out of the seat. The adjustable insert x (left picture top of page 36) enhances the comfort of the child up to approx. OPENING THE ATON CANOPY Pull the canopy panel away from the seat and turn the canopy up. To fold away the canopy lift the canopy panel slightly and turn the canopy back to its basic position. oPENING THE ATON BASIC CANOPY Pull the canopy cover over the carrying handle adjustment. To fold away the canopy cover release the velcro and pull it over the top end of the baby seat. CYBEX TRAVEL-SYSTEM Please follow the instruction manual supplied with your push chair. In order to attach the CYBEX ATON please place it against driving direction on the adapters of the CYBEX buggy. You will hear an audible CLICK when the baby seat is locked into the adapters. Always double check if the baby seat is securly fastened to the buggy. DEMOUNTING To unlock the baby seat keep the release buttons r pressed and then lift the shell up. PRODUCT CARE In order to guarantee the best possible protection for your child, please take note of the following: · All important parts of the child seat should be examined for damages on a regular basis. [. . . ] In order to guarantee a proper disposal of the child seat, please contact your communal waste management or administration of your place of residence. In any case, please take note of the waste disposal regulations of your country. PRODUCT INFORMATION If you have questions please contact your dealer first. Brand name and type of car and the position where the seat is mounted normally. [. . . ]