User manual CYBEX ATON 5

[. . . ] For the protection of your car On some car seat covers which are made of a sensitive material (e. In order to avoid this, you should put a blanket or a towel underneath the child seat. The carrying handle can be adjusted into three different positions: A: Carrying/Driving-Position. When using ATON in combination with ATON Base or ATON Base-fix the driving-position of the handle changes from A to B. [. . . ] In case of an emergency brake or accident, an unsecured child seat may injure other passengers or yourself. 18 IT UK In order to guarantee the best possible safety for all passengers make sure that . 19 •• Make sure that the carrying handle a is in the upper position A (see page 10). (The feet of the baby point in the direction of the backrest of the car seat). €• CYBEX ATON can be used on all seats with a threepoint automatic retractor belt. In the front, your child is usually exposed to higher risks in case of an accident. When securing your child with a two-point belt, this may result in injuries or death of the child. €• Make sure that the horizontal marking on the safety sticker p is parallel to the floor. 21 •• Insert the lap belt k into the blue belt guides m on both sides of the car seat. €• Pull the diagonal belt l in driving direction to tighten the lap belt k. €• Pull the diagonal belt l behind the top end of the baby seat. €• Bring the diagonal belt l into the blue belt slot n on the back. In some cases the buckle q of the car safety belt may be too long and reach into the belt slots of the CYBEX ATON, making it difficult to install the ATON securely. Removing the car seat •• Take the seat belt out of the blue belt slot n in the back. €• Open the car buckle q and take the lap belt k out of the blue belt slots m. 25 •• that the car buckle q is not reaching all the way to the blue belt slot m •• that the car belt is tight and not twisted •• that the ATON is vertically installed on the car seat (see marking) NOTE!The CYBEX ATON is exclusively made for forward facing car seats, which are equipped with a 3-point belt system according to ECE R16. Removing the insert The insert, which is preinstalled when purchased, helps to support lying comfort and fit for the smallest babies. In order to remove the insert please loosen the cover in the baby seat, lift the insert a little bit and take it out of the seat. The adjustable insert x (left picture top of page 33) enhances the comfort of the child up to approx. 27 Pull the canopy panel away from the seat and turn the canopy up. Opening the ATON Basic canopy Pull the canopy cover over the carrying handle adjustment. [. . . ] €• If the car is exposed to direct sunlight for a longer period of time, the child seat must be taken out of the car or covered with a cloth. €• Examine all plastic parts of the seat for any damages or changes to their form or color on a yearly basis. €• If you should notice any changes, you must dispose of the seat. Changes to the fabric - in particular the fading of color - are normal and do not constitute a damage. [. . . ]