User manual CYBEX CALLISTO

[. . . ] Do not carry additional children, do not hang shopping bags from the handle bars or carry shopping bags on the stroller except in the stroller's basket. ­ Maximum load 2 kg, maximum load for the canopy pocket 0, 5 kg. ­ Damages caused by the use of accessories not approved by CYBEX, such as rain covers, buggy boards, bag hooks, etc. ­ It may be unsafe to use replacement parts other than those approved by CYBEX. [. . . ] B) To tighten the belts pull the strap on the front of the central harness buckle. C) To release the belt system press the release button located on the seat in front of the belt lock while pulling at the shoulder belts. D) To release the fasteners squeeze the grooves on left and right side of the central harness buckle. E) Adjust the length of the crotch strap with the corresponding slider under the seat cover. ADJUSTING THE HARNESS SYSTEM FOR NEWBORNS ­ Release the loops at the end of the shoulder straps from the triangle in the belt system, situated at the bottom of the backrest under the seat cover. ­ Completely pull the shoulder straps out of the holes in the backrest. Make sure to feed the straps back through the holes in the backrest mechanism and re-attach them to the triangle. ⭠To adjust the length of the shoulder straps to newborns please attach the inner loop of the shoulder strap ends to the triangular ring. Switch back to the upper holes as soon as the shoulder straps do no longer fit over the child´s shoulders. REMOVING THE HEADHUGGER AND SHOULDER PADS a) Remove the headhugger as soon as the headhugger does no longer fit over the child´s shoulders. B) Remove the velcros of the headhugger on the top left and right side on the back of the seat cover. Release the loops at the end of the shoulder straps from the triangle in the belt system, situated at the bottom of the backrest under the seat cover. ­ Completely pull the shoulder straps out of the holes in the backrest. c) Pull the shoulder straps through the shoulder pads and the headhugger. Make sure to feed the straps back through the holes in the backrest mechanism and attach them to the triangle. ATTACHING THE BUMPER BAR a) Slide in latches on left and right side into gadgets sewn into the seat fabric. B) Press buttons on left and right end of the bumper bar to take it off. RECLINING THE LEG REST a) Press the leg rest on both front edges and push down. RECLINING THE BACKREST a) Pull the recline lever on the back of the seat to recline the backrest in 4 different positions. ­ Lift the pushed primary lock lever to release the stretching system. B) Push down the secondary lock lever (extended bar on right side of the locking system). Fold the buggy together carefully until the safety clip is securely locked. [. . . ] This warranty shall not apply in the event that this product is taken or shipped to the manufacturer or any other person other than the retailer who initially sold this product to a consumer. Please check the product with respect to completeness and manufacturing or material defects immediately at the date of purchase or, in the event that the product was purchased in distance selling, immediately after receipt. In case of a defect stop using the product and take or ship it immediately to the retailer who initially sold it. In a warranty case the product has to be returned in a clean and complete condition. [. . . ]