User manual CYBEX ONYX

[. . . ] ­ The child should be clear of any moving parts while making adjustments. Prevent children from grabbing the stroller while folding and unfolding, as fingers can become trapped and scissoring actions are unavoidable. wARNING: ANY LOAD ATTACHED TO THE HANDLES AFFECTS THE STABILITY OF THE STROLLER. Do not carry additional children, do not hang shopping bags from the handlebars or carry shopping bags on the stroller except in the stroller's basket. [. . . ] -I Check of wheel systems a) Wheel system must be cleaned before applying the lubricant. For eliminate squeaking on you CYBEX buggy take only WD 40 and follow the mentioned pictures below. Please pay special attention to not apply the lubricant on any other part of the stroller (fabrics, tubes, etc. -II Applying of the lubricant a) Rear Wheel - Spray from the rear side of the buggy in the space between the rim and the housing on both sides. B) Front Wheel - Spray in the space between the rim and the housing on both sides. should this not avoid the squeaking , please remove the rim cap and apply the spray on the axle. C) Suspension - Apply some lubricant between the suspension slider and the housings. DISPOSAL When you are done using your CYBEX Onyx/Topaz, a proper disposal is important. Please contact your local waste management company to make sure you are taking the right steps to dispose of the CYBEX Onyx/Topaz. ASSEMBLING THE FRONT WHEELS ­ Fit the front wheels to the end of the frame until they engage with a "click". ATTACHING THE BUMPER BAR (TOPAZ ONLY) a) Slide in latches on left and right side into gadgets sewn into the seat fabric. B) Lift the activated primary lock lever to release the stretching system. C) Push down the secondary lock lever (extended bar on the right side of the locking system). the swivel Lock will engage automatically when it reaches the right position. B) Lift the Front Swivel Lock Lever up again to release the Swivel Lock. ­ Lie-flat position: Put the rear flap over the seat's back rest and fixate it with the two velcros underneath. USING THE HARNESS SYSTEM a) To fasten the harness system insert left and right side fasteners into the central harness buckle. B) To tighten the belts pull the strap on the front of the central harness buckle. C) To release the belt system press the release button located on the seat in front of the belt lock while pulling at the shoulder belts. D) To release the fasteners squeeze the grooves on left and right side of the central harness buckle. ADJUSTING THE HARNESS SYSTEM FOR NEWBORNS a) Release the loops at the end of the shoulder straps from the triangle in the belt system, situated at the bottom of the backrest under the seat cover. B) Completely pull the shoulder straps out of the holes in the backrest. [. . . ] In the event that a manufacturing or material defect should appear, we will ­ at our own discretion ­ either repair the product free of charge or replace it with a new product. To obtain such warranty it is required to take or ship the product to the retailer, who initially Sold this product to a customer and to submit an original proof of purchase (sales receipt or invoice) that contains the date of purchase, the name of the retailer and the type designation of this product. This warranty shall not apply in the event that this product is taken or shipped to the manufacturer or any other person other than the retailer who initially sold this product to a consumer. Please check the product with respect to completeness and manufacturing or material defects immediately at the date of purchase or, in the event that the product was purchased in distance selling, immediately after receipt. [. . . ]