User manual CYBEX RUBY

[. . . ] Prevent children from grabbing the stroller while folding and unfolding, as fingers can become trapped and scissoring actions are unavoidable. wARNING: ANY LOAD ATTACHED TO THE HANDLES AFFECTS THE STABILITY OF THE STROLLER. Do not carry additional children, do not hang shopping bags from the handlebars or carry shopping bags on the stroller except in the stroller's basket. ­ Damages caused by the use of accessories not approved by CYBEX, such as rain covers, buggy boards, bag hooks, etc. [. . . ] ­ All CYBEX fabrics have been tested, but when the stroller is very wet, the water may permeate the lining through the bottom edges and seams and leave water stains on the upholstery. This product was approved according to the EN 1888:2003 + A1/A2/A3:2005 standard. SERVICE In general the Cybex pushchairs will run smooth without any problems. A dry and/ or dusty environment can have a negative effect on the wheel systems. To avoid this it is very important that the wheel systems will be regularly checked, cleaned and lubricated. Please follow the instruction below to maintain the wheel systems (wheel axles & suspension system). -I Check of wheel systems a) Wheel system must be cleaned before applying the lubricant. For eliminate squeaking on you CYBEX buggy take only WD 40 and follow the mentioned pictures below. Please pay special attention to not apply the lubricant on any other part of the stroller (fabrics, tubes, etc. -II Applying of the lubricant a) Rear Wheel Spray from the rear side of the buggy in the space between the rim and the housing on both sides. B) Front Wheel Spray in the space between the rim and the housing on both sides. should this not avoid the squeaking , please remove the rim cap and apply the spray on the axle. C) Suspension Apply some lubricant between the suspension slider and the housings. DISPOSAL When you are done using your CYBEX RUBY, a proper disposal is important. Please contact your local waste management company to make sure you are taking the right steps to dispose of the CYBEX RUBY. ASSEMBLING THE FRONT WHEELS ­ Fit the front wheels to the end of the frame until they engage with a "click". B) Lift the activated primary lock lever to release the stretching system. C) Push down the secondary lock lever (extended bar on the right side of the locking system, see picture 3). the swivel Lock will engage automatically when it reaches the right position. B) Lift the Front Swivel Lock Lever up again to release the Swivel Lock. Lie-flat position: Put the rear flap over the seat's back rest and fixate it with the two velcros underneath. USING THE HARNESS SYSTEM a) To fasten the harness system ­ insert left and right side fasteners into the central harness buckle. [. . . ] This warranty shall not apply in the event that this product is taken or shipped to the manufacturer or any other person other than the retailer who initially sold this product to a consumer. Please check the product with respect to completeness and manufacturing or material defects immediately at the date of purchase or, in the event that the product was purchased in distance selling, immediately after receipt. In case of a defect stop using the product and take or ship it immediately to the retailer who initially sold it. In a warranty case the product has to be returned in a clean and complete condition. [. . . ]