User manual CYBEX SOLUTION X2

[. . . ] Please always store the instruction manual in the drawer so it is at hand in case you would like to look something up. Then insert the drawer all the way in the provided opening in the seat. Please make sure that the plastic parts of the child seat never get jammed (e. System) pads on both sides into the mounting holes (z), then push down until they click into place. [. . . ] To avoid this, you should put a blanket or a towel underneath the child seat. ­ Should the headrest of the vehicle seat interfere, please pull it out completely and turn it around or take it off entirely. the backrest (a) optimally adjusts to almost any inclination of the vehicle seat. For the best possible protection of your child, the seat must be in a normal upright position!The backrest of the Solution X2 should rest flat against the upright part of the car seat. Pushing the booster rearwards the seat should be tightly pressed against the seat. In cars with a special seat configuration (1) the drawer should be removed (2). For children with a body weight above 22kg (ECE- group III) the Solution X2 should always be used without drawer. When using the Solution X2 without the drawer, please store the instruction manual on the rear side of the backrest under the elastic cover. Pull out the three-point belt and lead it in front of your child to the belt buckle. Now pull the lap belt (n) tight by pulling the diagonal belt (f) until there is no slack. The diagonal belt and lap belt should both be inserted in the bottom belt guide at the side of the belt buckle. The belt buckle of the car seat (l) must under no circumstances reach into the bottom belt guide (k). If the belt strap is too long, the child seat is not suitable for this vehicle. The lap belt (n) should be placed in the bottom belt guides(k) on both sides of the seat (d). Teach your child from the beginning to always pay attention to a tight belt and that it should pull the belt tight by itself if necessary. The lap belt must, on both sides, run as low across the groin of your child as possible in order to take optimal effect in case of an accident. Now lead the diagonal belt (f) through the upper red belt guide (g) in the shoulder rest (e) until it is inside the belt guide. Please make sure that the diagonal belt (f) runs between the outer edge of the shoulder and your child`s neck. If necessary, adjust the running of the belt by adjusting the height of the headrest. In order to ensure the maximum safety for your child, please check prior to the ride whether . ­ the lap belt (n) runs in the bottom belt guides (k) on both sides of the seat. [. . . ] ­ Examine all plastic and metal parts of the seat for any damages or changes about their form or colour on a yearly basis. If you notice any changes, you need to dispose of the child seat or it must be examined by the manufacturer and replaced if necessary. ­ Changes to the fabric, in particular the fading of colour, are normal after yearlong use in a car and do not constitute a fault. DISPOSAL At the end of the durability of the child seat, you must dispose it properly. [. . . ]