User manual DAIKIN FTXG25JV1BW

[. . . ] For safety reason the operator must read the following cautions carefully. Be sure to follow all precautions below: they are all important for ensuring safety. WARNING CAUTION If you do not follow these instructions exactly, the unit may If you do not follow these instructions exactly, the unit may cause property damage, personal injury or loss of life. cause minor or moderate property damage or personal injury. Never do. Never touch the air conditioner (including the remote controller) with a wet hand. Be sure to follow the instructions. [. . . ] · In FAN mode The air flow rate is fixed to the maximum setting. · When using priority-room setting See "Note for multi system" (page 20. ) 14 OUTDOOR UNIT QUIET Operation OUTDOOR UNIT QUIET operation lowers the noise level of the outdoor unit by changing the frequency and fan speed on the outdoor unit. This function is convenient during night. To start OUTDOOR UNIT QUIET operation 1. Press "QUIET button". ·" " is displayed on the LCD. To cancel OUTDOOR UNIT QUIET operation 2. Press "QUIET button" again. ·" " disappears from the LCD. 1, 2 NOTE Note on OUTDOOR UNIT QUIET operation · If using a multi system, this function will work only when the OUTDOOR UNIT QUIET operation is set on all operated indoor units. However, if using priority-room setting, see "Note for multi system" (page 20. ) · This function is available in COOL, HEAT, and AUTO modes. (This is not available in FAN and DRY mode. ) · POWERFUL operation and OUTDOOR UNIT QUIET operation cannot be used at the same time. Priority is given to the function of whichever button is pressed last. · If operation is stopped using the remote controller or the main unit ON/OFF switch when using OUTDOOR UNIT QUIET operation, " " will remain on the remote controller display. 15 INTELLIGENT EYE Operation "INTELLIGENT EYE" is the infrared sensor which detects the human movement. To start INTELLIGENT EYE operation 1. Press "SENSOR button". ·" " is displayed on the LCD. To cancel the INTELLIGENT EYE operation 2. Press "SENSOR button" again. ·" " disappears from the LCD. 1, 2 [EX. ] When somebody in the room · Normal operation. ON TIMER at 7:00 a. m. Display (The unit operating) Combined ATTENTION In the following cases, set the timer again. · After replacing batteries in the remote controller. 19 Note for Multi System What is a "Multi System"? This system has one outdoor unit connected to multiple indoor units. Selecting the Operation Mode 1. With the Priority Room Setting present but inactive or not present. Outdoor unit Living room C A room B room room When more than one indoor unit is operating, priority is given to the first unit that was turned on. In this case, set the units that are turned on later to the same operation mode (*1) as the first unit. Otherwise, they will enter the Standby Mode, and the operation lamp will flash; this does not indicate malfunction. · AUTO mode automatically selects COOL mode or HEAT mode based on the room temperature. Therefore, AUTO mode is available when selecting the same operation mode as that of the room with the first unit to be turned on. CAUTION Normally, the operation mode in the room where the unit is first run is given priority, but the following situations are exceptions, so please keep this in mind. If the operation mode of the first room is FAN Mode, then using Heating Mode in any room after this will give priority to heating. In this situation, the air conditioner running in FAN Mode will go on standby, and the operation lamp will flash. See "Priority Room Setting" on the next page. 2. [. . . ] (OPERATION lamp flashes. ) · The air conditioner may malfunction with lightning or radio waves. Turn the breaker OFF, turn it ON again and try operating the air conditioner with the remote controller. · Remove the object and attempt operation again using the remote control. If the panel still does not open, contact your dealer if the operation lamp is still flashing. 26 Call the service shop immediately. WARNING When an abnormality (such as a burning smell) occurs, stop operation and turn the breaker OFF. [. . . ]