User manual DAIKIN UNIFIED ON OFF CONTROLLER

[. . . ] This means the on/off of the equipment is controlled by the remote room programmable thermostat. There are two types of schedule timers 1) 7 day timer with 5 actions per day, for space heating and domestic hot water 2) 24 hour timer with 5 actions, only for outdoor unit quiet operation Hint: When programming the schedule timers use the menu, press to go back a step in the menu. to advance through the will be displayed To enter the schedule timer function press Once into the first schedule timer menu use the to select the desired program. [. . . ] 1) Space heating 2) Domestic hot water 3) Outdoor quiet function To enter any of the schedule timers press 01 Daikin Altherma high temperature remote controller guide Setting the schedule timer (continued) 1) 7 Day schedule timer The selected program will be flashing (either the of the week). or symbol and also the days Use the To enter the chosen day push now appear). to adjust the day of the week. (if this is done on space heating this screen will If the schedule timer has been previously programmed then you can view each schedule by using until the clock symbol begins to flash. When programming for the first time it will be necessary to push the action 1 next to the clock. These buttons will change the room set point (desired room temperature) as long as no third party room thermostat is fitted. To alter or add a schedule push and hold down 02 Daikin Altherma high temperature remote controller guide This button will change the desired function of the schedule timer from a set water flow temperature to weather dependant mode and finally to switching the unit off (please see note). Repeat until settings flashes up on the controller and the previous step until either you don't require any further actions or a maximum of 5 actions have been selected. Push and hold Please remember to use if required. Note: If turning the space heating off in the schedule timer it may prevent the unit from switching back on by the schedule timer. This is not a fault, the schedule timer has to be adjusted so the unit never has an off function. 16°C; or even reduce the water flow temperature down to 25°C to make sure the unit is only required to maintain a background temperature. This will allow you to switch off the space heating schedule timer in the summer months by switching allowing the domestic hot water schedule timer to carry on operating as before. to off, Once all the schedule timers have been programmed use normal remote controller screen. until you are back to the Activating the schedule timer To activate the schedule timer push controller deactivating the schedule timer. and the clock will be displayed on the left hand side of the controller. Push it again and the clock symbol will disappear from the 04 Additional information Last command If there is no external room programmable thermostat, the controller works on last command basis i. e. [. . . ] Push it again and the clock symbol will disappear from the 04 Additional information Last command If there is no external room programmable thermostat, the controller works on last command basis i. e. if you change the water flow temperature or desired room temperature, then this will stay the same until it is either changed or there is an action programmed in the schedule timer such as water temperature change or off function. Domestic hot water mode It is possible to boost the domestic hot water if a shortage occurs. This setting will override any current setting at the time of operation. [. . . ]