User manual DIGITECH BASS DRIVER

[. . . ] Protect the power cord from being walked on or Supplementary Information: pinched particularly at plugs, convenience receptacles, The product herewith complies with the requirements of the Low and the point where they exit from the apparatus. Unplug this apparatus during lightning storms or when amended by Directive 93/68/EEC. Servicing is required when Sandy, Utah 84070, USA Date: August 12, 2002 the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the European Contact: Your local DigiTech Sales and apparatus has been exposed to rain or moisture, does Service Office or not operate normally, or has been dropped. [. . . ] DigiTech's exclusive AudioDNATM technology is what makes the Bass Driver more than a standard overdrive stompbox. Rather than working with a single distortion circuit, the Bass Driver features a Morph knob that blends three totally distinct overdrive and distortion types. You now get a wide variety of overdrive sounds that can be dialed in quickly and easily. Turn this knob clockwise to increase the output level, and counter-clockwise to decrease the output level. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. Use the proper supply for your area's Mains line voltage. 1 234 5 11 10 9 6 7 8 4. Blending in dry signal helps maintain the bottom end that is usually lost when using a standard overdrive or distortion stompbox. At the Blend knob's maximum position, only distortion signal is heard. Experimenting with different Blend and Morph knob settings provides tremendous flexibility in the overall distortion sound. The maximum position is a classic high gain fuzz that will push your bass tone over the edge when you need it. Experiment with different Morph and Blend knob settings to hear the wide variety of sounds the Bass Driver is capable of creating. Connecting a 1/4" instrument cable to this jack engages battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. 7. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the chassis exposing the battery compartment. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. [. . . ] Make sure the battery cable does not interfere with the spring or pedal switch arm. Push the opposite pin in and lower the other side of the pedal into place over the depressed pin. When the pedal is properly fastened, both released pins are flush with the outer side of the pedal. Pedal Pedal Switch Arm 9V DC Battery Pedal Release Pin Battery Compartment Spring Pedal Release Pin Pedal Chassis SPECIFICATIONS: · Controls - Level, Tone, Blend, Morph, On/Off Pedal · Jacks - Input, Out 1 (Amp), Out 2 (Mixer) · Input Impedance - 1 MOhms · Output Impedance - 100 Ohms · Power Supply - 9V Alkaline Dry Battery · Power Consumption - 4. 8Watts (w/optional PS200R power supply) · Battery Life - Approximately 4 hours (with continuous usage) · Dimensions - 4 15/16"(L) x 3 1/8"(W) x 2 1/8"(H) · Weight - 1. 38 lbs. [. . . ]