User manual DIGITECH HOTHEAD

[. . . ] Do not install near any heat sources such as radiators, Safety: IEC 60065 (1998) heat registers, stoves, or other apparatus (including EMC: EN 55013 (1990) amplifiers) that produce heat. Protect the power cord from being walked on or Supplementary Information: pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Unplug this apparatus during lightning storms or when Voltage Directive 72/23/EEC and the EMC Directive 89/336/EEC as amended by Directive 93/68/EEC. [. . . ] 7. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. NOTE:The information contained in this manual is subject to change at any time without notification. Some information contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed. The information contained in this version of the owner's manual supersedes all previous versions. The Hot Head Distortion is a multi-purpose pedal for any music style where distortion is needed. Armed with flexible Low, High, and Gain controls, the Hot Head can dial in just the right tone for your setup. If you just want a little dirt or you need your amp to sound like a full stack, the Hot Head lets you rock with the best. Turn this knob clockwise to increase the output level, and counter-clockwise to decrease output level. Turn this knob clockwise to increase the low frequency content, and counter-clockwise to decrease the low frequency content. Use the proper supply for your area's Mains line voltage. 1 234 5 11 10 9 DISTORTION 6 7 8 4. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. Turn this knob clockwise to increase the amount of distortion, and counter-clockwise to decrease the amount of distortion. Connecting a guitar cable to this jack engages battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the chassis exposing the battery compartment. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. [. . . ] Make sure the battery cable does not interfere with the spring or pedal switch arm. Push the opposite pin in and lower the other side of the pedal into place over the depressed pin. When the pedal is properly fastened, both released pins are flush with the outer side of the pedal. SPECIFICATIONS: · Controls - Level, Low, High, Gain, On/Off Pedal · Jacks - Input, Amp Out, Mixer Out · Input Impedance - 1 MOhms · Output Impedance - 100 Ohms · Power Supply - 9V Alkaline Dry Battery · Current Draw ~ 17mA (at 9VDC) · Power Consumption - 4. 8Watts (w/optional PS200R power supply) · Battery Life - Approximately 18 hours (with continuous usage) · Dimensions - 4 15/16"(L) x 3 1/8"(W) x 2 1/8"(H) · Weight - 1. 38 lbs. [. . . ]