User manual DIGITECH PDS2730

[. . . ] Harman Music Group 11. WARNING:To reduce the risk of fire or electric 8760 South Sandy Parkway shock, do not expose this apparatus to rain or Sandy, Utah 84070 USA moisture. Refer to labels on the unit, including bottom cover, for Fax: (801) 568-7583 other markings and pertinent information. Product name: Tone Driver Product option: all (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent. ) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. [. . . ] DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. DigiTech reserves the right to make changes in design, or make additions to, or improvements upon this product without incurring any obligation to install the same on products previously manufactured. 6. The consumer forfeits the benefits of this warranty if the product's main assembly is opened and tampered with by anyone other than a certified DigiTech technician or, if the product is used with AC voltages outside of the range suggested by the manufacturer. 7. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. NOTE:The information contained in this manual is subject to change at any time without notification. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. Out 2 (Mixer) Jack This output features DigiTech's CITTM cabinet modeling technology, that lets you run the pedal directly into a mixer or recorder input without having to use a guitar amplifier. Connections The Tone Driver has a single input (INPUT) and a pair of outputs (AMP and MIXER). The two outputs give you the following options: running into a guitar amplifier, or running directly to a mixing console or recording device, or both. The MIXER output uses DigiTech's advance CITTM cabinet modeling technology for an authentic guitar amplifier sound without using an amp. Follow these setup directions: 1. Turn the volume down on the amplifier/mixer you are connecting to. 7. Turn on the pedal by pressing the pedal switch, and gradually turn up the level to the desired listening level. Battery Replacement 1. Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. [. . . ] Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. Connect a new battery to the battery cable and put it back in the battery compartment. [. . . ]