User manual DIGITECH RPX USB INSTALLATION GUIDE

[. . . ] Installing DigiTech USB Drivers You must install the USB drivers to use the RPx400's USB connection with your computer. There are different installation procedures for Windows XP users and Windows 2000 users. Follow the directions in the section that applies to your operating system. Windows XP Users Take the RPx400 out of the box and plug the power in. You will see multiple messages pop up from the task bar indicating that your computer has found a new USB device. [. . . ] Under MIDI music playback>Default device, open the pull-down menu and make sure your MIDI device is selected. Windows 2000 Users Select Start>Settings>Control Panel. Under Sound Playback>Preferred device, open the pull-down menu and make sure your sound car is selected. Under Sound Recording>Preferred device, open the pull-down menu and make sure your sound car is selected. Under MIDI Music Playback>Preferred device, open the pull-down menu and make sure your MIDI device is selected. 4. These options only need to be changed once now that the drivers are installed. Later we will change the settings in Pro Tracks to use the RPx400 for audio and MIDI. At this point you are ready to use the RPx400 to record with Pro Tracks. If you are anxious to record, skip the Setting Up the RPx400 MIDI Section D. Install DigiTech X-Edit Editor/Librarian Installing X-Edit allows you to edit and store your presets on your computer. Exit any programs that are still running before beginning the X-Edit Installation procedure. This software will automatically be installed by the X-Edit installer if it is not found on your computer. To ensure that . NET installs smoothly, Microsoft recommends that you disable your anti virus software before continuing. Once . NET and X-Edit are installed, you can reenable your anti virus protection. CAUTION: If you are running Windows 2000 and McAfee AntiVirus, please read the following note: If you are running McAfee Antivirus, Microsoft recommends that you completely un-install (NOT just disable) McAfee Antivirus from your computer. McAfee interferes with Microsoft's . NET installation process and must be removed to ensure a smooth installation. Once the . NET and XEdit installation is compete, you may re-install McAfee and re-enable your anti-virus protection. If it is no longer open, you can re-open it by selecting Start>Run and entering d:\instmenu. exe (where d:\ is the letter of your CDROM drive). and select DigiTech X-Edit. The installer will now check your computer for Microsoft . NET Framework. This could take several minutes and you might see the progress bar complete and start over again several times as well. When the . NET installer has completed, you will need to restart your computer if you are running Windows 2000. [. . . ] Verify that the Input and Output port settings still have RPx400 USB MIDI selected. DigiTech RPx should now be displayed as the Connected Surface in the Control Surfaces Window. Pro Tracks can now respond to the RPx400 for automated recording functions. G. Under the Input Drivers settings, select DigiTech USB 1-2 In/Out and DigiTech USB 3-4 In Only and deselect all other options. [. . . ]