User manual DIGITECH VOCAL 300

[. . . ] All other servicing should be referred to qualified service personnel. For units equipped with externally accessible fuse receptacle: Replace fuse with same type and rating only. Electromagnetic Compatibility Operation is subject to the following conditions: ·This device may not cause harmful interference. ·This device must accept any interference received, including interference that may cause undesired operation. ·Operation of this unit within significant electromagnetic fields should be avoided. DECLARATION OF CONFORMITY Manufacturer's Name: Manufacturer's Address: DigiTech 8760 S. [. . . ] Note: It may be necessary to consult your mixer's owners manual for the proper mixer setup. Balanced XLR Cable Balanced XLR Cable or From Line Level Output MASTER Stereo Operation 1. Turn the INPUT GAIN knob completely counter-clockwise (7 o'clock) position. Set the mixer's master fader to its minimum position (no output signal). Connect an 1/4" TS cable or stereo TRS "Y" cable from the Vocal 300's 1/4" OUTPUT to the 1/4" line input of the selected mixer channel. Set the pan controls on the selected mixer channel hard left and hard right. 7. While singing, gradually turn up the Vocal 300's INPUT GAIN knob until the INPUT CLIP LED lights with the strongest signals. Note: It may be necessary to consult your mixer's owners manual for the proper mixer setup. 3 Balanced XLR Cable 1/4" Stereo "Y" Cable or From Line Level Output MASTER Modes and Functions Performance Mode The Vocal 300 initially powers up in performance mode. Each press of this button moves to the next row of effects in the matrix. LOW, MIDRANGE, HIGH, AND MASTER LEVEL Knobs - These knobs control the Bass, Mid Level, Treble, and Master Level of the presets. FOOTSWITCHES ­ The UP and DOWN footswitches move through the presets (1-40 User and 41-80 Factory). While in preset bypass, you can select the next preset using the UP and DOWN footswitches. Expression Pedal - Controls the assigned parameter of the current preset. 4 Edit Mode The Vocal 300 lets you create your own presets, and modify existing presets. Modify the parameters in the selected row using the LOW, MIDRANGE, HIGH, and MASTER LEVEL knobs. When changes are made, the Store LED lights, and the abbreviated parameter name with a space followed by a two digit parameter value is displayed. To move to the next effect in the Matrix, press the SELECT button again. Note: Pressing the UP or DOWN footswitches returns you to Performance mode. Pressing the BYPASS footswitch bypasses all effects. Store Mode After modifying a preset, you must store your settings to one of the 40 User Preset locations. To store changes to a preset or store a preset to a different location, do the following: 1. The Store LED begins blinking on and off, and the first character of the name flashes. Use the MIDRANGE knob to move to the next character (left or right) in the name. If you want to change where the preset is stored, rotate the MASTER LEVEL knob to select a new preset location. V-Switch is a pressure sensitive virtual switch, that turns the Vocal Character module off and on. The expression pedal must be calibrated for the Vocal Character module to work. The expression pedal will continue to control the parameter it is assigned to regardless of the Vocal Character status. [. . . ] Delay Level - Rotate the MASTER LEVEL knob to adjust the delay effect level. Reverb Using reverb in recorded program material gives the listener a sense that the material is being performed in an actual room or hall. This similarity to actual acoustic space makes reverberation a useful tool in recorded music. Type/Off - Rotate the LOW knob to select 1 of 8 reverb types and to turn the reverb on and off. Damping - Rotate the HIGH knob to adjust the amount of high frequency damping in the reverb signal. [. . . ]