User manual DOD ACOUSTEC

[. . . ] POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that described in the operating instructions. [. . . ] bp will appear in the LED Display (5), this will bypass the AcousTEC completely. Tuner activation To activate tuner, press and hold the Footswitch (1) of the program you are currently using. To tune, pluck string repeatedly and the second vertical row of LED's will show status of note, sharp or flat. Factory reset Caution this function will revert AcousTEC to factory default. Hold down both the Compressor and Reverb buttons while powering up the AcousTEC. The AcousTEC has now reverted to factory default. ACCESSORIES FOR THE AcousTEC Gig Bag VCC1 Volume Continuous Controller DECLARATION OF CONFORMITY DOD Electronics 8760 South Sandy Parkway Sandy, Utah, 84070 Telephone (801) 566-8800 FAX (801) 566-7005 International Distribution: 3 Overlook Drive, Unit 4 Amherst, New Hampshire 03031 U. S. A. FAX (603) 672-4246 AcousTEC is a registered trademark of DOD Electronics Copyright © 1998 DOD Electronics Printed in U. S. A. AcousTEC Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: AcousTEC Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1, 2, 3 EN 55013: (1990) EN 55020: (1991) EMC: Supplementary Information: The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. Sandy Parkway Sandy, Utah 84070, USA Effective: February 23, 1998 European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 Warranty 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one (1) year. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. The foregoing is in lieu of all other warranties, expressed or implied, and DOD neither assumes nor authorizes any person to assume for it any obligation or liability in connection with the sale of this product. In no event shall DOD or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. MULTI EFFECTS PROCESSING 4 5 6 INPUT, OUTPUT, 7 AND ALL THOSE FUNKY 3 2 8 9 10 11 12 1 1. Program and bank selector footswitches These footswitches provide access to the AcousTEC's banks/programs. Power adaptor input This is where the DOD PS200R power supply is connected. [. . . ] Detune, 3@5 cents, 3@10 cents, 3@15 cents. Delay: 01-99 Mono 01-59 Multitap 60-99 100ms to 500ms increasing in 100ms steps, increasing feedback and delay mix. 100ms to 500ms increasing in 100ms steps, increasing feedback and delay mix. Reverb: 1-9 1-3: 4-6: 7-9: Room, 3 levels. Stadium, 3 levels. Compression: 1-3 1: 2: 3: Low Medium High Contour:1-15 (*need brief overview of ranges) EQ Low: EQ Mid: EQ High: -12 to +12 in steps of 2 dB. -12 to +12 in steps of 2 dB. 18-2249-A QUICK S T ART K T 1. Safety Info: Read all safety instructions before operating AcousTEC 2. INPUT Input Connection: Insert 1/4" cable from guitar to AcousTEC input. [. . . ]