User manual DOD FX50

[. . . ] When the TONE control is straight up, the distortion signal is unchanged. Turning the TONE control clockwise boosts the high frequencies (treble) of the distortion signal and turning the TONE control counterclockwise boosts the low frequencies (bass) of the distortion signal. GAIN: Adjusts the amount of distortion applied to the original signal. [. . . ] GAIN: Adjusts the amount of distortion applied to the original signal. Turning the GAIN control clockwise increases the amount of distortion applied to the original signal; it also increase the sustain of the guitar notes. FOOT SWITCH: Switches the distortion effect IN/OUT of the signal path. (Use the DOD PS200R power supply to eliminate the need for batteries. ) The FX50 is a very high gain preamplifier that when overdriven produces a distorting of the input signal and help sustain the notes longer. These effects simulate the characteristic distortion of a guitar amplifier turned up so high that it "clips" the signal, distorting it. The FX50 has an extra amount of gain boost in its upper range for a greater distortion effect. This pedal makes the distortion sound aggressive at any amplifier loudness level and helps to sustain your notes. OPERATION OF THE FX50 FX50 Supra Distortion produce distortion effects which are a modification of the original guitar sound. These effects amplify the original signal overdriving the internal circuitry, causing a distortion sound. Should your FX50 require service, contact your DOD FX pedal dealer for return / repair information. · Use of any AC adapter other than the DOD PS200R will void the warranty of this product. · If the FX50 fails to switch in or out or the LED indicator stays lit, the battery needs to be replaced. · Remove the battery whenever the unit is not going to be used for an extended period of time. This will prevent possible damage due to leaking battery fluids. IMPORTANT NOTES · The FX50 battery is in use whenever the INPUT jack is plugged in. If you are not using the FX50, be sure to unplug the cable from the INPUT jack. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. 4. Proof-of-purchase is considered to be the burden of the consumer. 3. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, where all parts and labor will be covered up to a period of three years. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. 2. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. 1. [. . . ] The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. 2. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD Warranty Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. Manufacturer's Name: DOD Electronics Corporation Copyright © 1998 DOD Electronics Corporation Printed 2/98 FX50 18-1055-A Manufacturer's Address: 8760 S. [. . . ]