User manual DRAKE DIGITAL DRMM12 DATASHEET

[. . . ] DRMM12 Rack Mount The DRMM12 Rack Mount supports a single Drake Power Supply and up to (8) modular Drake digital headend units to configure a professional quality, modular, headend system, which optimizes rack space. [. . . ] Excessive heat will shorten the life of components and individual module(s). Power supply performance will also be degraded without proper cooling. GRAY END CAP (DECORATIVE) P/N: 4801560) 1 If desired, the supplied gray end caps can be installed over the mounting ears of the DRMM12 and secured by the rack support screws. Prior to sliding the power supply into the right-hand side top and bottom slide rails of the DRMM12, loosen the #6-32 screw located on the top surface of the power supply. Position the free end of the ground wire lug (other end of wire fastened to DRMM12) under the #6-32 screw, and tighten the screw to secure the ground wire. If necessary, use the following steps to remove the Drake Power Supply from the rack: 1) Remove the module immediately adjacent to the Drake Power Supply. Be aware that the module power cable will become disconnected from the rear when the module is removed. 2) Now grasp the edge of the Drake Power Supply front panel and remove the unit from rack. [. . . ] CUSTOMER SERVICE AND PARTS TELEPHONE: +1 (937) 746-6990 TELEFAX: +1 (937) 743-4576 WORLD WIDE WEB SITE: http://www. rldrake. com TM is a trademark of the R. L. [. . . ]