User manual DRAKE DIGITAL LBS2250 DATASHEET

[. . . ] The LBS2250 has a nominal 5 dB level drop from a LNB input to any of the front panel L band outputs. The LBS is programmed and powered from the PS151 power supply/controller that is installed with the transcoders in the RMT150. To install the LBS, select any one of the power cables that connect the PS151 to the SCTx860 transcoders and loop this connection through the LBS2250. Then connect another power supply cable between the LBS Power Output and the transcoder. [. . . ] Drake LLC P/N: 38522486 A-11-2007 Printed in U. S. A. LBS2250 L BAND SWITCH SPECIFICATIONS L band Amplified Multiswitch - specification applies to each input, A or B Frequency Range: 950 to 2250 MHz Input Level Range: - 60 to -25 dBm from LNB L Band Output Levels: Rear LNB Output - Unity gain ref. Isolation, LNB A to LNB B: 30 dB minimum Output Combiner Frequency Range: Inputs: Output: Insertion Loss, any input to output: Return Loss: TM 54 to 1000 MHz 10 1 13 dB nominal, 14. 5 dB maximum 14 dB typical, all ports LNB Powering LNB A 18 VDC @ 250 mA, maximum LNB B 13 or 18 VDC, selectable @ 250 mA, maximum. Protection: Short circuit protection. LBS2250 L BAND SWITCH Three Year Limited Warranty R. L. DRAKE LLC warrants to the original purchaser this product shall be free from defects in material or workmanship for three (3) years from the date of original purchase. DRAKE LLC or an authorized Drake service facility will provide, free of charge, both parts and labor necessary to correct defects in material and workmanship. To obtain such a warranty service, the original purchaser must: (1) Retain invoice or original proof of purchase to establish the start of the warranty period. DRAKE LLC or the nearest authorized service facility, as soon as possible after discovery of a possible defect, of: (a) the model and serial number, (b) the identity of the seller and the approximate date of purchase; and (c) A detailed description of the problem, including details on the electrical connection to associated equipment and the list of such equipment. DRAKE LLC or the nearest authorized service facility, or ship the same in its original container or equivalent, fully insured and shipping charges prepaid. Correct maintenance, repair, and use are important to obtain proper performance from this product. DRAKE LLC determines is due to: (1) Improper maintenance or repair, including the installation of parts or accessories that do not conform to the quality and specifications of the original parts. All implied warranties, if any, including warranties of merchantability and fitness for a particular purpose, terminate three (3) years from the date of the original purchase. DRAKE LLC's entire obligation with respect to this product, and the original purchaser shall have no other remedy and no claim for incidental or consequential damages, losses or expenses. Some states do not allow limitations on how long an implied warranty lasts or do not allow the exclusions or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Customer Service and Parts Telephone: +1 (937) 746-6990 World Wide Web Site: http://www. rldrake. com TM LBS2250 L BAND SWITCH SERVICE INFORMATION You may contact the R. L. DRAKE Service Department for additional information or assistance by calling +1 (937) 746-6990, Monday through Friday, between 8:00 A. M. DRAKE Service Department by E-mail at the following address: TechSupport@rldrake. com Should you want to return your unit for service, package the unit carefully using the original carton or other suitable TM container. Write your return address clearly on the shipping carton and on an enclosed cover letter describing the service required, symptoms or problems. [. . . ] The unit must be sent to the following address: Service Department R. L. DRAKE LLC 230 Industrial Drive Franklin, Ohio 45005 U. S. A. Be sure to include your street address which will be needed for UPS return. UPS Surface (Brown Label) takes 7-10 days to reach us depending on your location, Blue takes 2-3 days. Send the unit in a way that it can be traced if we can't verify receipt of shipment. [. . . ]