User manual DRAKE DIGITAL PS150 QUICK GUIDE

[. . . ] PS150/151 POWER SUPPLY Power Supply 1INSTALLATION The PS150 and PS151 power supplies are designed to TM provide power for Drake model SCT1860, SCT2860, SCT3860, and SCT4860 transcoders when mounted in the model RMT150 rack mounting tray. The PS151 can power a full tray of 10 of any mix of the transcoder models listed above. [. . . ] Normally, the leftmost transcoder, as viewed from the front panel, will be number 1 with transcoders connected in sequence to the right. The rightmost transcoder will thus be plugged into socket number 10 on the supply. Note that transcoders do not have to be connected in any specific numerical order but the above method is preferred to make it easier to identify a particular transcoder during setup, if necessary. Carefully route the power cable for the front mounted fans between the power supply and the adjacent transcoder and plug the fan cable into the socket on the rear of the supply, just above the line cord. When all cables are connected, plug the line cord into a nominal 120 VAC outlet. MECHANICAL Dimensions: (WxHxD): ---4. 25in. (PS151) CONNECTORS RS232 Out/In: ----------- (2) Type DB-9 interface connectors DC Output: --------------- (10) Molex 39-31-0060 (Power supply assembly employs short circuit and overvoltage protection). AC Power Cord: --------- 54" with USA, 3 prong, 120 V plug PS150/151 REAR PANEL CONNECTIONS 1. AC Input - The power supply accepts standard 100 to 240 VAC, 50/60 Hz inputs (and -10%/+10% of that voltage range). DC Output - The polarized connectors provide 10 sets of output connections for the compatible transcoder units. RS232 Remote Control Interface - If the SCT system transcoders are to be controlled from a PC via the RS232 interface, the serial port cable from the PC should be connected to the 'RS232 IN' connector on the supply. The 'RS232 OUT' connector is used to connect to the 'RS232 IN' port on another PS150/151 or to a PS100 if additional transcoders are to be controlled. This process may be repeated until a maximum of 7 PS150/151s (70 transcoders max. ) are connected. In addition, up to 63 SCT860s could also be controlled by the same connection if PS100s are also daisy changed in this connection. s INSTALLING THE PC SOFTWARE FOR THE DRAKE TRANSCODER CONTROL PROGRAM To install the control software, place the CDROM in the PC CDROM tray. [. . . ] If Acrobat Reader is not installed on your system, select option 3 from the auto run menu or click on the rs405eng. exe file on the CDROM to install a complimentary copy. s R. L. CUSTOMER SERVICE AND PARTS TELEPHONE: +1 (937) 746-6990 TELEFAX: +1 (937) 806-1576 WORLD WIDE WEB SITE: http://www. rldrake. com TM is a trademark of the R. L. [. . . ]