User manual DRAKE DIGITAL RMM4 DATASHEET

[. . . ] (1. 3 kgs). INSTALLATION Secure modules to the RMM4 using the supplied #4-40 x 1/2" PAN PHL screws (R. Drake part # 3320351) at the four corners of each module as shown. Standoffs (16 total), located at the four corners of each module. DC Power Cables (4) typical. (Observe proper polarity and maximum ratings. ) AC Cord FIGURE 2 - Rear Panel View of RMM4 MODULE INSTALLATION All mini modules install through one of the four openings in the front panel of the RMM4. [. . . ] Retain Instructions--The safety and operating instructions should be retained for future reference. Follow Instructions--All operating and use instructions should be followed. Do Not Use Attachments--not recommended by the manufacturer or they may cause hazards. Water and Moisture--Do not use this product near water--for example, near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool--and the like. Accessories--Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the appliance. Ventilation--This video product should never be placed near or over a radiator or heat register. This video product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. To ensure reliable operation of the video product and to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. Grounding or Polarization--This video product is equipped with a 3- wire line cord. Mise à la terre ou Polarisation--Cet appareil est équipé avec un cordon d'alimentation à trois fils. Power Sources--This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied to your home, consult your appliance dealer or local power company. Power-cord Protection--Power-supply cords should be routed so they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. Lightning--For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet. Power Lines--An outside antenna system should not be located in the vicinity of overhead power lines, other electric light or power circuits, where it can fall into such power lines or circuits. [. . . ] Safety Check--Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Outdoor Antenna Grounding--Before attempting to install this product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Use No. 10 AWG (5. 3mm2) copper, No. 8 AWG (8. 4mm2) aluminum, No. 17 AWG (1. 0mm2) copper-clad steel or bronze wire or larger, as ground wire. [. . . ]