User manual EBENCH KH 2204

[. . . ] · · · · the environmental limits are not exceeded (see Section 2). Extremely dry air can cause static charges that can lead to faulty functions. outdoors in winter) can permanently darken the liquid crystal display. Transportable devices are particularly at risk to accidental damage. You can reduce this risk by observing the following: · · Protect the device against heavy stresses, such as impacts and falls. [. . . ] "ON" appears initially in the display, followed by the tuned frequency. b) Switching Off Immediately To switch the the device off, press the button SNOOZE / Radio off , or . . . ¾ the button RADIO ON / SLEEP repeatedly until "OFF" appears in the display. c) Switching Off with Time Delay If you would like to listen to the radio for a while longer, for instance before falling asleep, but would like the device to switch off automatically after a certain amount of time (10. . . 90 minutes), . . . ¾ press the button RADIO ON / SLEEP only enough times until the desired number of minutes is shown in the display ("10 . . . If you do not alter the remaining time, the display will switch back to the tuned frequency. ¾ button RADIO ON / SLEEP again. 8 KH2025-2026_IB_UK 01. 04. 2004 11:29 Uhr Seite 9 6. Receive Mode As soon as the device is switched on as described under 5. , it is already in receive mode. a) Setting the Volume º Press the buttons VOLUME to adjust the volume. b) Selecting the Reception Range (Band) ² Select the desired reception range with the sliding switch: - USW = Ultra Short Wave - MW = Medium Wave - SW = Short Wave - LW = Long Wave c) Changing the Medium Wave Rage The frequency range and tuning intervals of MW vary by region: Set the sliding switch to - up in the region "USA" - down in the region "Europe". d) Searching for Stations ´ Press briefly on one of the two TUNING buttons to search upward or downward in steps. Pressing the button again will continue the scan. 9 KH2025-2026_IB_UK 01. 04. 2004 11:29 Uhr Seite 10 e) Short Wave (SW) Sensitivity If the the scan process frequently lasts too long, for instance because too many signals are received in the evening, the sensitivity can be reduced to short wave (local reception). ´ Press one of the TUNING buttons briefly to set the time by minute. ´ Hold one of the TUNING buttons pressed to change the time in 10-minute steps. b) Setting the Date ¾ Press the button MODE until the date blinks in the display. ´ Press one of the TUNING buttons briefly to set the date by day. ´ Hold one of the TUNING buttons pressed to change the date in 10-day steps. c) Accepting the Time / Date You do not have to do anything to accept the time and date ­ the newly set time or date is accepted immediately after making the setting. 13 KH2025-2026_IB_UK 01. 04. 2004 11:29 Uhr Seite 14 d) Setting the Home Time Region Set the time region here in which you typically reside: µ Press the button MODE until LOCAL CITY appears in the display. ´ Use the TUNING buttons to select your home time region: Code UTC LON MUN FRA PAR ROM CAI IST MOW KWI DXB KHI Applies to Time Region Difference to UTC 0 0 1 1 1 1 2 2 3 3 4 5 14 Universal Coordinated Time . . . . . . Karachi / Pakistan . . . . . . . . . . . . . . . . . . . . . . DAC BKK SIN HKG PEK TYO SYD NOU AKL HNL ANC YVR LAX DEN CHI MEX NYC YYZ YUL CCS RIO BUE Dacca / Bangladesh . . . . . . . . . . . . . . . . . . - 3 Buenos Aires / Argentina . . . . . . . . . . - 3 KH2025-2026_IB_UK 01. 04. 2004 11:29 Uhr Seite 15 e) Setting Travel Destination Time Regions Once you have selected a home time region as described under d): µ Press the button MODE until only CITY appears in the display. ´ Use the TUNING buttons to select the travel destination from the same table, as used previously under d). The device now shows the time difference between the travel destination region and your home time region. If you would like to be woken by the radio, you should select the desired station and volume level before going to sleep. [. . . ] Miscellaneous » To lock the buttons against accidental operation, hold the button KEY-LOCK pressed for 5 seconds until KEY LOCK appears in the display. Fold out the prop to set the device at an incline. 18 KH2025-2026_IB_UK 01. 04. 2004 11:29 Uhr Seite 19 When the device is switched off, and the date and time appear in the display in alternation: ¶ Press the button Alt. - the symbol : When the device is switched off, only the time will be displayed. - DATE and : When the device is switched off, the time and date will be displayed in alternation. [. . . ]