User manual EBODE IR LINK MINI

[. . . ] The product should only be repaired or serviced by qualified and authorized service personnel. Never use old and new batteries or different types of batteries together. Remove the batteries when you are not using the system for a longer period of time. [. . . ] Plug the yellow mini plugs of the 3IREDB into one of the yellow labelled "EMITTERS" jacks of the IRHUB4 Connecting Hub. Plug the IRQC cable into one of the yellow labelled “EMITTERS” jacks of the IRHUB4, and the other side into the 3. Position the IRLPRO Mini IR Receiver in a location outside of the equipment cabinet or closet that will have a straight line-of-sight view of your Hand Held Remote(s). The Receiver can be fixed to the surface by using the double side tape pad. Plug the red mini-plug of the IRLPRO Mini IR Receiver into the red labelled "IR RCVR" jack on the IRHUB4 Connecting Hub. NOTE: It is important that you use an unswitched AC outlet so that the IR system is always active for system power ON commands. 1mm "C" plug of the Power Supply Adapter into the "+12VDC" jack on the IRHUB4 Connecting Hub. STATUS You can send a Power Status signal to the IRLPRO Mini IR Receiver by connecting a power adapter to this connection (not supplied), which e. When the A/V device or contact is switched on, the Amber Status LED will light up in the IRLPRO Mini IR Receiver so that you can see that the A/V device is switched on. Fig 2 Fig 3 31-12-2010 5 IR Link Pro Mini On the top of the IRHUB4 cabinet there is a cut out for jumper placement. You have 3 different status led response positions: - Default, JP on position JP1: Feedback LED active & Status LED not-active/unused - JP on position JP2: Feedback LED & Status LED both always OFF - JP cable on position JP2 with voltage supply within range: Feedback LED & Status LED active (depending on external voltage being present) - JP on position JP3: Feedback LED active & Status LED always ON (based on power to IRHUB4) 6. Operation The IR repeater system should now operate each of the controlled components. When the system is installed correctly, you should see a Blue "talk-back" LED flash on the front of the IRLPRO Mini IR Receiver when you aim your hand held remote control(s) at it and press the buttons. How to avoid and solve possible problems Although the ebode IR Link Pro Mini is equipped with proprietary eIR2xTM (pronounced Irex) Technology, which guarantees a high level of immunity of InfraRed noise from direct sunlight, CFL lighting and Flat Panel TV’s (including Plasma, LCD and LED), in rare cases, the IRLPRO Mini IR Receiver may have to be moved to a different location if the unit is picking up unexpected interference. [. . . ] Upp till sex IRLPRO Mini IR-mottagare kan anslutas parallellt till skruvterminalingångarna på IR Link IRHUB-seriens anslutningsmoduler (t. Kabelspecifikationer för längre kabel till angränsande rum: 3-ledare, 24AWG/0, 2 mm 2 solid eller platt kabel upp till 50 m, 22AWG/0, 35 mm2 upp till 100 m, 20AWG/0, 5 mm2 upp till 200 m och 18AWG/1 mm2 upp till 300 m (oskyddad OK). User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of ebode products. [. . . ]