User manual ELICA OM TOUCH SCREEN

[. . . ] The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames. [. . . ] Cover that surface with a protective covering and place all canopy hood parts and hardware in it. € In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version). Installation of an electric socket and/or a hole for the passage of the discharge tube). Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Only for some models An aesthetic flue can be purchased as an optional accessory. Check with the authorized dealer whether the model in your possession envisages this possibility. We advise installing the hood after having purchased the flue to check with certainty the most suitable installation. If necessary (in the case of walls not perfectly perpendicular or in the presence of walls partly covered with tiles) apply two D spacers in correspondence with the definitive fixing holes (click fixing). € Trace a centre line on the wall to facilitate the montage (1), position the hole template so that the middle line printed on it corresponds to the centre line previously drawn and that the lower side of the grill corresponds to the lower part of the hood once mounted (2). € Make two holes with the 8 mm Ø drill and fix the support bracket with two dowels and wall screws (3). € Open the steam screen and remove the grease filter (see relative paragraph). € Hang up the hood (4), adjusting its position (5-6) and from the inner part of the hood mark two points for the definitive fixing (7). Remove the hood and make two 8 mm Ø holes (8), insert two wall dowels, hang the hood up again and fix it definitively with two screws (9). € Connect the electricity (10), but leave the hood disconnected from the general electric panel of the house. € If the hood is to be used in the suction version, install the flange supplied in the kit on the exit hole of the hood (11A - suction version – also install a fumes discharge tube of suitable dimensions) instead of the deflector (11F Mounting Before beginning installation: • Check that the product purchased is of a suitable size for the chosen installation area. € To facilitate installation, remove the fat filters and the other parts allowed and described here, dismantle and mount it. • Remove the active carbon (*) filter/s if supplied (see also relative paragraph). This/these is/are to be mounted only if you want lo use the hood in the filtering version. € Check (for transport reasons) that there is no other supplied material inside the hood (e. If the hood is to be used in the suction version, remove, if supplied with the kit, the carbon filter and the fixing rods (on the back of the grease filter – see relative paragraph). [. . . ] Repeter operasjonen for å deaktivere signaleringen, først lyser både knapp 1 og 2, så lyser bare knapp 1 for å angi deaktiveringen. Manglende overholdelse af kravene for rengøring af emhætten, og for udskiftning og rengøring af filtrene, medfører brandfare. Ved at sørge for, at dette produkt bortskaffes korrekt, bidrager brugeren til at forhindre eventuelle negative konsekvenser for miljøet og for den almene sundhedstilstand. For yderligere oplysninger om behandling, genindvinding og genbrug af dette produkt bedes man kontakte det lokale kontor for affaldsbehandling, renovationsselskabet eller den butik, hvor apparatet er købt. [. . . ]