Detailed instructions for use are in the User's Guide.
[. . . ] Before connecting your appliance to the power supply, carefully read the instructions in the chapter entitled "Electrical connection". Replacing the power cable should only be carried out by an authorised service engineer. The manufacturer cannot be held responsible for any damage resulting from incorrect installation. Precautions to be taken against frost If your appliance is exposed to temperatures below 0°C, the following precautions must be taken: · Close the tap and disconnect the inlet hose. [. . . ] Load the washing, close the drum and the lid of your washing machine. A
Selecting the spin speed Press the "Spin" (Essorage) pushbutton to change the spin speed, if you want your washing to be spun at a different speed to the one selected by the appliance. you can also select "No spin" , "Rinse hold" or "Night silence plus"3). you can also select "No spin" , "Rinse hold" or "Night silence plus"3). Selecting options You must select the different options after selecting the programme and before pressing the "Start/ Pause" pushbutton (see "Programmes table"). If one of the options is not compatible with the selected programme, the "Start/ Pause" pushbutton flashes red. "Daily" option (Quotidien) This option allows to run a wash cycle of lightly soiled laundry at reduced time. "Super quick" option (Rapide) The washing time will be reduced depending on the programme selected. "Rinse plus" option (Rinçage plus) The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. temporary : Press the "Rinse plus" (Rinçage plus) pushbutton. Load 1, 0 kg Possible options Rinse hold
3, 0 kg 5, 0 kg 5, 0 kg 5, 0 kg
Rinse hold Rinse hold, Rinse plus
1) Reference programme for test confirming to CEI 456 standard (Cottons Eco 60° programme): 49L / 0, 95kWh / 160min
Care and cleaning
Unplug the appliance before cleaning. Descaling the appliance To descale the appliance, use an appropriate noncorrosive product designed for washing machines. Read product label for recommended amounts and how often descaling should be carried out. The exterior Use warm soapy water to clean the exterior of the appliance. Dispenser box To clean, proceed as follows :
Water inlet filters To clean, proceed as follows :
Object trap Regularly clean out the object trap which is located at the bottom of the drum :
16 electrolux
Operating Problems
Numerous checks were carried out on your appliance before it left the factory. However, should you Problems The washing machine doesn't start or doesn't fill: notice a malfunction, please refer to the sections below before contacting the after-sales service. causes · The appliance isn't plugged in correctly, the electrical installation isn't working, · The lid of your appliance and the drum shutters aren't closed firmly, · The programme start command hasn't been properly selected, · There is a power failure, · The water supply has been cut off, · The water inlet tap is closed, · The water inlet filters are dirty, · The drainage U-piece is fixed too low (see installation section). The out of balance detector has been activated : washing is unevenly distributed in the drum, · The "Drain" programme or "Night Silence Plus" or "Rinse hold" option have been selected, · The height of the drainage U-piece is unsuitable. Too much detergent has caused foam to overflow, the detergent is unsuitable for machine washing, the drainage U-piece isn't attached correctly, the drainage filter hasn't been put back in place, the water inlet hose is leaking. The detergent is unsuitable for machine washing, there is too much washing in the drum, the wash cycle is unsuitable, there isn't enough detergent. The appliance fills but empties straight away: The washing machine doesn't rinse or doesn't empty:
You have found water around the washing machine:
Wash is unsatisfactory:
The appliance vibrates, is noisy:
· All packaging have not been removed from the appliance (see installation section), · The appliance isn't level and is unbalanced, · The appliance is too close to the wall or furniture, · washing is unevenly distributed in the drum , · The load is too small. [. . . ] Technical Specifications
DIMENSIONS Height Width Depth 850 mm 400 mm 600 mm 230 V / 50 Hz 2300 W Minimum Maximum 0, 05 MPa (0, 5 bar) 0, 8 MPa (8 bar) Type 20/27
LINE VOLTAGE /FREQUENCY POWER CONSUMPTION WATER PRESSURE Connection to water supply
Installation
Remove all protective packaging for transit before using for the first time. Keep in case needed for future transit: Transporting a non-secured appliance may damage internal components and cause leakages and malfunctions. Unpacking
1 2 3 4
5
6
18 electrolux Untying
1
3 4 1 2 2
Drainage The connector at the end of the flexible hose can be attached to all common types of standpipe. Attach the connector to the standpipe with the hose clamp supplied with the appliance4)
3
4
Fit the U-piece on the drainage hose. [. . . ]