User manual EPSON STYLUS TX219

[. . . ] Do not use aerosol products that contain flammable gases inside or around the printer. Except as specifically explained in your documentation, do not attempt to service the printer yourself. [. . . ] When the ink pads are saturated, the printer stops and Epson support is required to continue printing. Turn off the printer, remove the jammed paper, and then turn it back on. Photos are not selected or the ovals are marked incorrectly on the index sheet. The paper type is not selected or ovals are marked incorrectly on the index sheet. If it is, check that there are no problems with the card and try again. O Some ink is consumed from all cartridges during the following operations: print head cleaning and ink charging when an ink cartridge is installed. O For maximum ink efficiency, only remove an ink cartridge when you are ready to replace it. The use of non-genuine ink may cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic printer behavior. Information about non-genuine ink levels may not be displayed, and use of non-genuine ink is recorded for possible use in service support. O Make sure you have a new ink cartridge before you begin replacement. Once you start replacing a cartridge, you must complete all the steps in one session. o Leave the expended cartridge installed until you have obtained a replacement. O Do not open the ink cartridge package until you are ready to install it in the printer. O Other products not manufactured by Epson may cause damage that is not covered by Epson's warranties, and under certain circumstances, may cause erratic printer behavior. [. . . ] R & 18, 21 Make sure you loaded paper and placed the original correctly. R & 14, 18 If the edges of the copy or photo are cropped off, move the original slightly away from the corner. [. . . ]